Transport Position, Handlebar; Assembling The Cutting Equipment; Fitting A Blade Guard, Grass Blade And Grass Cutter - Husqvarna 1151187-95 Operator's Manual

• Fit the wiring as shown.
• Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that
the machine is in a comfortable working position when
it hangs from the harness. Tighten the knob.

Transport position, handlebar

• The handlebar can easily be turned to fit along the
shaft for easier transportation and storage.
• Loosen the knob. Turn the handlebar clockwise so that
the throttle handle rests against the engine.
• Now twist the handlebar around the shaft. Tighten the
knob.
• Fit the transport guard to the cutting attachment.
14 – English
ASSEMBLY
Assembling the cutting
equipment
!
!
IMPORTANT! If a saw blade or grass blade are to be
used the machine must be equipped with the correct
handlebar, blade guard and harness.
Fitting a blade guard, grass blade
and grass cutter (232R)
D
A
L
WARNING!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
WARNING! Never use a cutting
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
G
F
E
B
C
M