Table of Contents
Advertisement
(2) Creating a Setting Name
The DRM-1 allows creation of a setting name consisting
of
up
to
eight
alphanumeric
characters
including
symbols.
If not necessary, this entire step becomes
optional.
•
■
.'."**'
® Place the cursor under the^characterto be changed,
using the CURSOR control keys.
(D Use the VALUE keys to select the new character.
+SET-00*
| Use the CURSOR control and VALUE keys.
MY-DRUMS
I
<Characters Valid in a Setting Name>
!" =$*S" ()* + .-.
012345B7B9: :< = >?a
ABCDEFGHIJKLMNOPQRSTUVWXYZ
¥. A_\
abcdefghijk Imnooarstuvvvxyz
— sp
Space '
* The SELECT key, intended for selecting the voice
number, allows access to setting numbers only for the
SELECT SETTING screen.
All edit commands dis
cussed hereafter are valid only for parameters selected
with the SELECT key.
VOICE
The VOICE SETTING screen timbres to be assigned to
any of the voice settings numbered from 00 to 15. It
also determines the settings for the PHASE effect.
When the VOICE key is pressed, the upper half of the
display reads VOICE SETTING ## (where ## is the
current
setting
number); the
lower half shows the
current voice number, the name of the timbre assigned
to that voice, and the sound mode. Pressing the VOICE
key a second time switches the lower half of the dis
play to the PHASE setup screen.
Qj Selecting a Sound Name
(D Press the VOICE key to bring up the VOICE SET
TING screen.
VOICE
SETTING00
00=
SNARE
1:I00M
t Voice number
t Sound name
j *-
(VOICE
SETTING
screen)
Sound mode
L-Sound number
(2) Select the voice number of the data to be changed,
using the SELECT key.
00=
SNARE
1
00M
I
Press the SELECT keys.
(Select a voice number from 00 to 15.)
1 5
(D Select the sound number of a timbre to be assigned
to thecurrent voice, using the VALUE keys.
[00= SNARE
1 : 10 DM I
J Use the VALUE keys.
C48
£
Built-in sound source
00 to 22
ROM card sound source
(Timbres selected from up
to four cards)
(The sound source alternates each time a key is pressed.)
Figure 2
< Sound Number and Sound Mode >
The DRM-1
has built-in data for timbres which
are parameter compatible with the ROM cards for
the DDD-1/5. Each timbre is assigned a unique code
called the sound number, which appears on the
display
when
a
voice
parameter
assignment
is
changed.
Built-in sound source
ROM card sound source
Figure 3
Built-in sound source selected
Twelfth sound from the
built-in sound source
Memory card sound source
selected
Memory card in the CARD
2 slot selected
First sound from the memory
card
Note 1: This procedure overrides the previous setting
and sets the PHASE to 000.
Note 2: When using a ROM card, be sure to set it in
place before pressing the VOICE key, which
instructs the DRM-1 to check the slots for a
missing card before loading data.
(2) Selecting a Sound Mode
The POLY, MONO, and EXCLUSIVE sound modes each
provide
independent
control
over the voice settings
defining
the
way the
DRM-1
will generates sounds
consisting of up to twelve notes at a time.
1) Press the VOICE key to select VOICE SETTING
screen.
(2) Move the cursor to the sound mode field, using
the CURSOR control keys.
VOICE
SETTING00
00=
SNARE
1:I00M
(VOICE
SETTING
screen)
T Current sound mode
Advertisement
Table of Contents
