Throttle Control; Parking Brake - Cub Cadet Commercial S6031 Tank S Operator's Manual

Speed Control Pedals
The speed control pedals are located on the right side of the
traction unit. The speed control pedals must be in the neutral
position to start the tractor engine.
Pushing the forward pedal causes the mower to move forward.
Pushing the reverse pedal causes the mower to move backward.
Consequently, these pedals control all of the fore and aft
movements of the tractor. Driving utilizing these control pedals
is quite different from conventional tractors, and will take some
practice to master. Refer to the Operation section for instructions
on using the speed control pedals.
Ignition Switch
The ignition switch is located on the RH console
to the right of the operator's seat. The ignition
switch has three positions as follows:
OFF — The engine and electrical system is turned
off.
RUN — The tractor electrical system is energized.
START — The starter motor will turn over the engine. Release the
key immediately when the engine starts
NOTE: To prevent accidental starting and/or battery discharge,
remove the key from the ignition switch when the tractor is not
in use.
PTO (Power Take-Off) Switch
The PTO switch is located on the RH console
to the right of the operator's seat next to the
ignition switch.
The PTO switch operates the electric PTO
clutch mounted on the bottom of the engine
crankshaft. Pull the switch knob upward to
engage the PTO clutch, or push the knob
downward to disengage the clutch.
The PTO switch must be in the "disengaged"
position when starting the engine.
Digital Tachometer and Hour Meter
The tachometer/hour meter panel is located on the RH console
to the right of the operator's seat. The hour meter records the
hours that the tractor has been operated in the digital display.
The tachometer provides engine speed (RPM), and service
reminders (oil, lube) in the digital display.
The tachometer/hour meter is activated all the time, and
indicates engine speed only when the engine is running. Keep a
record of the actual hours of operation to assure all maintenance
procedures are completed according to the instructions in this
manual and the engine manual.

Throttle Control

The throttle control is located on the RH console to the right
of the operator's seat. When set in a given position, a uniform
engine speed will be maintained. The trottle control moves
between the fast
Push the throttle control handle forward to increase the engine
speed. The tractor is designed to operate with the throttle
control in the fast position
being driven and the mower deck is engaged.
OFF
Pull the throttle control handle rearward to decrease the engine
RUN
speed.
Choke Lever
START
The Choke lever is located on the right side of the mower next
to the operator's seat. The Choke is operated manually when the
lever is moved forward past the detent. Having the Choke in the
On position helps the engine to start during initial start-up.
During normal operation the Choke should be OFF

Parking Brake

The parking brake is located on the left side
of the tractor and to the left side of the brake
pedal. Push the parking brake and brake pedal
down at the same time until it latches to engage
the parking brake. Push the pedal downward
and release to disengage the parking brake.
NOTE: If the speed control pedals are not in the
neutral position when engaging the parking
brake, the engine will stop. The parking brake
must be placed in the engaged position when starting the
tractor engine.
and slow positions.
(full throttle) when the tractor is
s 4 — c & f
ectiOn OntrOls
.
BRAKE
15
eatures