Advertisement
OPERATING INSTRUCTIONS
Turn the volume control on the remote control to it's off position.
Switch on the power using the on/off switch on the Active speaker rear panel
Adjust the volume control to increase the output sound level to your preferred level.
WARNING: Always turn the unit on and wait for a moment before turning the volume control
up. High signals levels can damage the system on startup
The system accepts line-level audio signals from sources such as PCs, Notebooks, CD/DVD
players, Minidisc players, iPod, Tuners etc
After use turn off the volume control, which disconnects the amplifier, and turn off the power
switch on the rear plate which turns the internal power supply.
TROUBLE SHOOTING
If the system is not operating correctly, please check the table below: If the problem persists
contact your AV reseller immediately and disconnect the system from the power.
Problem
No Sound from either speaker
No sound from Passive speaker
SPECIFICATIONS
Sahara Presentation Systems Plc
Output Power
Drive Units
Impedance
Frequency response
Separation
Signal/noise Ratio
Input Sensitivity (10% THD)
Distortion THD
Dimensions (mm)
Power Supply
Checks to be made
Check that the mains supply is switched
on at the wall socket
Check that the power switch at the
amplifier rear panel of the active speaker
is switched on
Check that the volume control is turned
up
Check that the audio cables to your audio
source are connected properly
Check that the audio source is active and
playing
Check the Mini jack cable connection at
the active speaker and the connection at
the passive speaker end
15 Watts x 2
4" x 2 + 1.5"x2
4 ohms
20Hz – 20 kHz
>35 dB
>60d B
<600 mV
<0.3%
143x252x173 mm
230 Volt/ 50Hz
Williams House, Hailey Road, Erith Kent DA18 4AA
Advertisement
