Advertisement
INSTALLATION GUIDE
1. Screw two of the speaker brackets to each of the speakers in the pre-drilled holes
provided
2. Select a suitable position for each of the speaker either side of the Interactive
whiteboard.
3. Fix one of the wall mounting screws into a suitable wall plug in the wall in a position
so that the speaker can be hung on this screw using the central "keyhole" wall mount.
Hang the speaker unit on this fixing and mark a hole position on the wall for the
position of the top speaker security bracket.
4. Drill and install a suitable wall plug for the top security bracket.
5. Hang the speakers using the central "Keyhole" wall mount and secure the speaker to
the wall with the screws provided into the top wall plug position.
6. Connect the 10m speaker cable provided into the active speaker using the RCA
connector in the base of the Active speaker. Measure and cut the raw end of the
cable to the length required to join the passive speaker to the amplifier. Strip off 7mm
of insulation from the cut end and insert into the speaker connections on the passive
speaker
7. Fix the wired remote control to a suitable position on the wall using the adhesive pad
provided
8. Connect the Audio cables with RCA connectors into the rear of the active speaker
unit and into the audio sources (or cable termination box if used)
9. Check that both the on/off switch and the Volume control on the wired remote control
switched off. Plug the power cable to the mains supply and switch the supply on.
10. Follow the Operating Instructions below
Sahara Presentation Systems Plc
Williams House, Hailey Road, Erith Kent DA18 4AA
Advertisement
