On Code 3 ® Lp 6000 Tm Series Frame - Code 3 ARROWSTIK AS-10 Installation & Operation Manual

TM
LP 6000 Series Frame:
1) If an LP lightbar is currently mounted on the vehicle, remove the lightbar from the vehicle roof and turn
it upside down. Rest it on cloth or some other soft surface. It is not necessary to disconnect the wiring.
2) Determine whether you have an early or late model LP 6000
smooth along the bottom (Figure 2). Late models have a depressed trough in the center of the base.
(Figure 3).
3) Mount the ArrowStik
an early model LP frame, refer to Figure 2. If you have a late model LP frame, use of the plastic shims
supplied in the parts bag will ensure level mounting of the ArrowStik
(refer to Figure 3). In either case, leave the mounting bolts loose until step 7.
4) Turn the lightbar right side up and attach the ArrowStik to its mounting bracket as shown in Figure 4.
Leave the mounting bolts loose so the ArrowStik can be moved from side to side.
5) Put the lightbar on the vehicle roof making sure not to scratch the vehicle. Check for clearance below
the lightbar as you proceed.
6) Reposition the lightbar and secure it to the vehicle.
7) Tighten the bolts that hold the ArrowStik mounting bracket to the lightbar, checking that the brackets
are aligned with each other.
8) Position the ArrowStik in the center of the vehicle and tighten the bolts that hold it to the mounting
bracket.
"
5
MOUNTING BOLT
16
"
5
FLAT WASHER
16
FIGURE 2
LP 6000 SERIES
(EARLY MODEL)
MOUNTING BRACKET
XL 5000 TM Series Frame:
1) If an XL Series Lightbar is already mounted on the vehicle,remove the speaker cover and then the lens
from one end of the lightbar by removing the six (6) screws holding it in place. Figure 5 illustrates three
of the screws on one side.
2) Remove the lightbar from the vehicle roof and turn it upside down. Rest it on cloth or some other smooth
surface. It is not necessary to disconnect the wiring.
3) At the same end, mark the location of the "U" bracket assembly on the lightbar frame (see Figure 5).
4) Remove the "U" bracket assembly by loosening the nuts and sliding it off the lightbar base.
5) If the ArrowStik is to be front mounted, slide the two carriage bolts into the front groove as shown in
Figure 6. Otherwise, slide both carriage bolts into the rear groove.
6) Re-secure the "U" bracket assembly in the position marked in Step 3 and replace the lens.
®
bracket on the front or rear of the LP 6000 Series frame as desired. If you have
MOUNTING BRACKET
FIGURE 4
3
™
Series frame. Early models are fairly
"
5
MOUNTING BOLT
16
"
5
FLAT WASHER
16
¼"
SPLIT WASHER
¼"
ACORN NUT
MOUNTING BRACKET
PLASTIC SHIMS
FIGURE 3
LP 6000 SERIES
(LATE MODEL)