Intex 10' (305cm) Owner's Manual page 10

3. Next slide the vertical legs into the belt loop located
in the middle of the pool liner. The bottom of the leg
is to be "inside" the white restraining rope (9) located
near the liner's bottom edge. Carefully slide the leg
into the belt loop and place the leg's bottom inside
the rope and then insert the top of the leg into the
bottom of the joint. Snap this leg into joint's holes by
aligning the holes and the spring-loaded pin. Attach
the leg's end cap (5) to the bottom of the leg (see
drawings 3.1 & 3.2).
4. • Grab the frame pool's top beams in 2 – 3 locations and "shake"
the pool to be sure all the joints, legs and beams "fit into each
other". Check and ensure all pins are in position by pushing all
the pins downwards through the holes (see drawing 4.1).
• Pull gently, in an outward direction, at the bottom of the leg
making sure the leg is inside the restraining rope. The leg is
to end up in an upright vertical position.
5. For pool liner with hose connectors (16' (488 cm) & below pools), if pool was purchased
without a filter pump, use two of the three plugs (11) and plug them into the black filter
pump outlets from the inside of the pool so water will not run out while filling.
If pool was purchased with a filter pump, see Krystal Clear™ Filter Pump Manual
first and then go to step #6.
6. • Before starting to fill pool with water, check to be sure that the drain plug inside the pool
is closed and the drain cap on the outside is screwed on tightly. Fill the pool with no
more than 1 inch of water; and look to see if there is any noticeable difference in the
slope of the pool floor.
IMPORTANT: If the water in the pool flows to one side, the pool is not completely
level. Setting up the pool on unlevel ground will cause the pool to tilt resulting in
the sidewall material bulging. If the pool is not completely level, you must drain
the pool, level the area or move the pool to a different area that is level, and re-fill
the pool.
• Begin to smooth out the remainder of wrinkles (from inside pool) by pushing out where
the pool floor and pool sides meet, or (from outside pool) reach under the pool side,
grasp the pool floor and pull out. If the ground cloth is causing the wrinkles then have 2
adults pull from either side to remove all wrinkles.
7. Water may be filled up to 4" (10 cm) from the
top (see drawing 4.2).
Before allowing anyone to use the pool, hold a family meeting and establish a set
of rules that include, at a minimum, the important safety rules and general
aquatic safety information in this manual. Review these rules on a regular basis
and with all users of the pool including guests.
SAVE THESE INSTRUCTIONS
(87IO) ROUND METAL FRAME POOL ENGLISH 7.5" X 10.5" PANTONE 295U 05/28/2007
POOL SET UP (continued)
IMPORTANT
3
8
9
3.2
3.1
5
4 inches
87IO
4
4.1
4.2
Page 10