Revert To Default Settings - BLIP Node L2i User Manual

Revert to default settings:

If you are not able to connect to the BlipNode, or the BlipNode IP address does not match your
current network you can revert to factory defaults by:

Opening the BlipNode cover.

Apply power and wait one minute for the
BlipNode to start-up.

Locate the button inside the BlipNode
(to the right in the picture below).

Press and hold the button for
between 3 and 10 seconds.

After releasing the reset button,
watch the green Power LED and verify
that it stops flashing, as the BlipNode
restarts with the default persistent
settings.
Page 5 of 9