Hargrove Firepit Burners Installation And Operation Manual

For lp/cng gas supply systems

Advertisement

Quick Links

INSTALLER: LEAVE THE INSTRUCTIONS WITH CONSUMER
WARNING: If the information in this manual is
not followed exactly, a fire or explosion may
result causing property damage, personal
injury or loss of life.
Do not store or use gasoline or other
flammable vapors and liquids in the vicinity
of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
1. Do not try to light any appliance
2. Do not touch any electrical switch; do not
use any phone in your building.
3. Immediately call your gas supplier from a
neighbor's
phone.
supplier's instructions.
4. If you cannot reach your gas supplier, call
the fire department.
Installation and service must be performed by a
qualified installer, service agency or the gas
supplier.
WARNING:
Improper installation, adjustment,
alteration, service or maintenance can cause
injury or property damage. Read the installation,
operating
and
thoroughly before installing or servicing this
equipment.
This equipment contains a burner orifice
specifically for the input gas and Btu rating.
Modifying or failure to use the factory orifice
may cause property damage, personal injury
or loss of life.
This equipment is intended for use with an input
of Natural or Propane gas only.
INSTALLATION AND OPERATION GUIDE
Firepit Burners
WARNING: FOR OUTDOOR USE ONLY
Follow
the
maintenance
instructions
FOR
HARGROVE
Clothing or other flammable materials should not
be hung from the appliance, or placed on or near
the appliance.
Children and adults should be alerted to the
hazards of high surface temperatures and
should stay away to avoid burns or clothing
ignition.
Young children should be carefully supervised
when they are in the area of the appliance.
Keep the appliance area clear and free from
combustible materials, gasoline and other
gas
flammable vapors and liquids.
Covers must be removed when burner is in
operation.
For installation on or over non-combustible floors
only.
NEVER LEAVE THIS APPLIANCE BURNING
WHILE UNATTENDED.
Installation and repair should be done by a
qualified service person. The appliance
should be inspected before use and at least
annually by a qualified service person. More
frequent cleaning may be required as
necessary. It is imperative that the burner and
circulating air passageways of the firepit be
kept clean.
Storage of the appliance indoors is permissible
only if the gas cylinder is disconnected and
removed from the appliance.
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Firepit Burners and is the answer not in the manual?

Questions and answers

Summary of Contents for Hargrove Firepit Burners

  • Page 1 INSTALLATION AND OPERATION GUIDE HARGROVE Firepit Burners WARNING: FOR OUTDOOR USE ONLY INSTALLER: LEAVE THE INSTRUCTIONS WITH CONSUMER WARNING: If the information in this manual is Clothing or other flammable materials should not not followed exactly, a fire or explosion may...
  • Page 2: Important Information

    IMPORTANT INFORMATION The Firepit must be used for outdoor spaces only. For the purpose of this requirement, an appliance is considered to be outdoors in an open environment or with walls and ceiling no more inclusive than: 1. With walls on all sides, but not with an overhead cover. 2.
  • Page 3 GAS CYLINDERS 1. This appliance shall be used with NATURAL and LP inlet gas supply only. The LP or CNG gas supply cylinder must be constructed and marked in accordance with the specifications for LP-gas cylinders or CNG-gas cylinders of the U.S. Department of Transportation (DOT).
  • Page 4 PARTS LIST PART# DESCRIPTION #1 SSFW18, 24, 30 Stainless Steel Fire-wheel burner SSFR36 Fire-ring if ordered in 36” #2 FPTP22 Hose kit with key valve #3 FCNW-18 Non-whistling flex connector #4 50-6-8 1/2” to 3/8” brass reducing elbow #5 49-6-6Z2 Brass elbow orifice holder #6 PPH-2 Orifice (2, bigger orifice hole for NG, smaller hole for LP)
  • Page 5 INSTALLATION NATURAL GAS OR LIQUID PROPANE WITH NO KEY VALVE 1. Make sure gas is shut off. 2. Connect proper hose to gas supply. 3. Connect the other end of the hose to the brass elbow orifice holder 4. Connect the appropriate orifice. The bigger orifice hole is for NG. 5.
  • Page 6 INSTALLATION NATURAL GAS OR LIQUID PROPANE WITH A KEY VALVE 1. Make sure gas is shut off. 2. Connect proper hose to gas supply. 3. Connect the other end of the hose to the valve. 4. Attach the other side of the valve to the flex connecter. 5.
  • Page 7: Limited Warranty

    8. Purchaser or user agrees to hold Hargrove Mfg Corp. harmless from any and all claims by the buyer as a result of injury or damage to an ultimate user or other person caused by the product sold herein by the seller to the buyer, whether the injury or damage results from the assembly, installation, operation, shipment, storage, or manufacture of this product.

Table of Contents