Hookups; Analog Hookup (Aio•8) - Mackie MDR 24/96 Operation Manual

Hookups

This section shows how the MDR24/96 is typically connected to both analog and
digital consoles (using the Mackie Analog and Digital 8•Bus consoles as
examples). These examples assume that the rest of your studio equipment
(monitors, sound sources, outboard processing, etc.) is already connected, or that
you know how to connect it.
Before you begin, note how the three eight-channel I/O cards are arranged on the
MDR24/96 rear panel: 1-8 is on the left, 9-16 is in the center, and 17-24 is on the
right. Labeling each cable before you begin will make connecting the MDR24/96 to
your console easier.
The specific hookups for each MDR24/96 I/O card are shown below.
Note: Note:
Note: Note: If you are us- Note:
ing a D8B console
Analog Hookup (AIO•8)
with either DIO•8,
PDI•8, or OPT•8
This example describes the hookup for the 24•8 analog console.
cards installed, then
Cables & Hardware
a Clock I/O card
(3) AIO•8 cards for MDR24/96
must also be in-
(6) Analog snakes, DB25 to eight 1/4" TRS phone plugs
stalled in the D8B to
properly synchro-
Hookup
nize its word clock
1. Connect three snakes to the MDR24/96 Inputs (bottom connector). If you
with the MDR24/96.
MDR24/96 back panel
50/60 Hz 475W 120VAC
1-8
ANALOG I/O ANALOG I/O ANALOG I/O
MDR24/96 AIO Cards
want to have the ability to route any console input to any recorder track,
then connect the 1/4" plugs on each of the three snakes to the like-
numbered Submaster/Tape Output jacks on the 8•Bus console. This works
as long as you don't record more than 8-channels at a time, since the
Submaster Outputs 9-16 and 17-24 are the same as outputs 1-8.
Alternately, you can connect the console's direct outputs to the recorder's
inputs, so that each console channel feeds the like-numbered recorder
track. Or, you can use a combination of direct and subgroup outs. The
hookup diagram below shows the MDR24/96 inputs connected to the
Submaster Outputs.
ANALOG I/O ANALOG I/O ANALOG I/O
SYNC ACC ETHERNET MIDI
TAPE IN/OUTS
9-16 17-24
8
16
24
TAPE IN/OUTS
7 5 3
8 6 4
15 13 11
16 14 12
23 21 19
24 22 20
7 6 5 4 3 2 1
15 14 13 12 11 10 9
23 22 21 20 19 18 17
1
TAPE RETURNS 1-8
2
9
TAPE RETURNS 9-16
10
17
TAPE RETURNS 17-24
18
24•8 SUBMASTER
/ TAPE OUTPUTS
Operation Guide
23