Figure 2-16. Removing Display Assembly Components - HP Pavilion zt1000 Service Manual

Screw, M2×4mm
Inverter PCA
Screws,
M2×4mm (2)

Figure 2-16. Removing Display Assembly Components

Reassembly Notes
•
Make sure the alignment hole in the inverter PCA fits over the corresponding post in the display
case.
•
Make sure the alignment hole in the wireless antenna fits over the corresponding post in the display
case.
•
Set the bezel in place on the display, then work your way around the bezel, firmly snapping the
bezel latches shut.
•
The rounded screw co
•
vers go on the screws at the top of the display bezel, and the flat covers go on the screws at the
bottom of the bezel.
Technology Code ID)
Screws,
M2.5x6mm (4)
Bluetooth antenna
Removal and Replacement
Screws,
M2×4mm (2)
802.11b
antenna
2-21