Bolens Service Manual page 12

18.6. Using a spring puller (MTD Part number 732-
0571), disconnect the two springs which are
attached to the rear portion of the tractor
frame.(Torque Bracket Extension Springs) See
Figure 27.
Springs attach to the frame here
NOTE: When re-installing the extension springs
after completing the repairs, install the right hand
spring first.
18.7. Place the deck engagement/lift lever in the
BLADES STOP position.
18.8. Using a 1/4 inch socket, remove both belt keep-
ers on either side of the engine pulley. See Fig-
ure 28.
NOTE: There are four belt keeper mounting
holes in the frame. Mark the holes prior to
removal to insure proper reassembly.
Belt Keepers
Figure 27
Figure 28
18.9. Using an air impact gun with a 5/8 inch socket,
remove the hex screw that secures the engine
pulley to the engine crankshaft.
18.10. Carefully lower the pulley off the crankshaft and
remove the belt from around it.
NOTE: A spacer is located between the engine
pulley and engine. Be careful not to lose the
spacer and be certain NOT to reinstall the
spacer upside down. See Figure 29.
Spacer
18.11. Disconnect the NEGATIVE (black) battery cable
from the battery, followed by the POSITIVE (red)
cable. See Figure 30.
Negative Cable
Battery Hold Down Rod
18.12. Detach the battery hold down rod and remove
both the battery and battery tray from the tractor.
See Figure 30.
10
Figure 29
Positive Cable
Figure 30