Base Ringer Melody & Volume; Recall Duration; Dial Mode; Register - Hyundai HDT-L3 User Manual

Base ringer melody & volume
1. Press during standby and press
PROG
flashing.
2. Press to select.
OK
3. Press to listen to and select from the 5 melodies.
4. Press to confirm your selection and you will be prompted to volume
OK
Setting.
5. Press to listen to and select from the different volume levels.
6. Press to confirm your selection.
OK
You have the option to turn off the base ringer.
You cannot program the base ringer if the handset has lost link with the
base. UNAVAIL will be displayed. Re-establish the link and try again.

Recall duration

When you are talking on the phone, pressing
There are 2 factory programmed recall timings for you to choose from. Check
with your local telephone company if you are not sure which duration to set
and the functions performed with the flash signal.
1. Press during standby and press
PROG
flashing.
2. Press to select. The current duration is now displayed.
OK
3. Press 1 or 2 directly or press
4. Press to confirm.
OK

Dial mode

Tone or pulse dialing mode can be changed in this menu.
1. Press during standby and press
PROG
flashing.
2. Press to select. The current setting is now displayed.
OK
3. Select 1 for TONE or 2 for PULSE or press
4. Press to confirm.
OK
If the dialing mode is set to pulse, you can press and hold the
temporary DTMF during off hook. "d" will be displayed on the screen. All the
digits dialed after "d" will be dialed as DTMF tones until you hang up.
or until you see
will send a flash signal.
until you see
to select.
until you see
to select.
key to set a

Register

Each handset can register to one base at a time only. The current base will
be deregistered when a new base is registered.
Each base can register up to 4 handsets.
1. Press during standby and press
PROG
icon flashing.
2. Press to select.
OK
3. Before you enter the PIN, press and hold
until a registration tone is emitted. The base is now in the registration
mode. (If the base is full and cannot take on any more handset, it will
emit a reject tone instead. See the section of Deregister to delete a
currently registered handset.)
4. Enter the PIN of the base and press
You will hear a confirmation tone if the registration is successful. The
handset label and the handset number will be displayed.
If the registration is not successful, you will see NOT REG on the handset.
Follow the procedure and try again.

Deregister

A handset can deregister another handset registered to the same base. It
cannot deregister itself.
1. Press during standby follow by the 9 key.
PROG
2. Enter the handset number (i.e. HS#2) to delete. The LCD will display 9-2.
3. Press and then
OK
4. Enter the PIN
5. Press to confirm.
OK

PIN code

A PIN is required for registration and deregistration. The ex-factory PIN is
0000 but you can change this code.
1. Press during standby follow by the 8 key.
PROG
2. Enter the current PIN and press
3. Enter the new PIN. It can contain from 0 up to 8 digits. Press
4. Repeat the new PIN and press
hear a confirmation tone if it is successful, or a reject tone if the same
PIN is not entered.
8
or until you see
on the base for 2 seconds
.
OK
.
OK
to confirm the new code. You will
OK
.
OK