Sloan Soap/Sanitizer Dipensers Installation & Operating Instruction Manual

Electronic and manual

Advertisement

Dispensers
Electronic
Dispensers
Dispensers
Installation & Operating
Instruction Manual
Thoroughly read this instruction booklet
before operating Sloan dispensers.
Keep this Installation & Operating
Instruction Manual with other product
information for future reference.
Manual Dispensers
SJS-1000 Soap Dispenser
SJS-1100 Foam Soap Dispenser
SJS-1400 Sanitizer Dispenser
Electronic Dispensers
SJS-1050 Touchless, Sensor-Operated
Soap Dispenser

Table of Contents

Consumables Chart
Page
2-3
4-7
8-9
9-10
11
11
11

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Soap/Sanitizer Dipensers and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Sloan Soap/Sanitizer Dipensers

  • Page 1: Table Of Contents

    Soap/Sanitizer Installation & Operating Instruction Manual Dispensers Thoroughly read this instruction booklet before operating Sloan dispensers. Keep this Installation & Operating Instruction Manual with other product information for future reference. Manual Dispensers SJS-1000 Soap Dispenser SJS-1100 Foam Soap Dispenser SJS-1400 Sanitizer Dispenser...
  • Page 2: Soap/Sanitizer

    Dimensions – Manual Models (Fig. 1) 1.41" (36 mm) 2.17" (55 mm) 10.04" Mounting hole (255 mm) 5.28" (134 mm) 4.41" 5.31" (112 mm) (135 mm) Soap/Sanitizer Pouches – Manual Models Parts – Manual Models (Fig. 2) (Fig. 3) Note the difference in the pouch nozzles.
  • Page 3: Dimensions

    Dimensions – Sensor Models (Fig. 4) 1.41" (36 mm) 2.17" (55 mm) 10.83" Mounting hole (154 mm) 6.07" (154 mm) 3.51" 5.75" (89 mm) (146 mm) Soap Pouch – Sensor Parts – Sensor Models (Fig. 5) Models (Fig. 6) Keyhole Insert the Key into the Mounting Keyhole, and the cover...
  • Page 4: Manual

    INSTALLATION AND SET-UP Parts Optional AC Adapter for Sensor Models Dispenser (1) 1. If an outlet is not available in the Key (1) installation area contact an electrician. Alcohol Wipe (1) 2. The power supply is AC100V-120V Screws (5) (50/60Hz). Wiring must conform to Wall Anchors (5) power supply requirements.
  • Page 5 When installing onto a concrete wall or STEP 4. drywall, drill 1” to 1.5” deep holes using a Installing the main body (Fig. 10) 1/4” drill bit. Mount plate with three wall Position the main body over the mounting anchors and screws. plate and snap into place.
  • Page 6 STEP 6. Fig. 14 Opening/closing the cover (Fig. 13) Place the key into the keyhole on the top of the dispenser. Holding the cover, open it toward you. Return the cover to its original position and press it until it snaps into place. Fig.
  • Page 7 Fig. 15 Foaming Soap Type Sanitizer/Soap Type Holder Holder Pouch Pouch How to set the foam pump How to set the liquid and spray pump Insert the nozzle into the holder hole. Place pouch into holder, align nozzle with pins and snap into position as shown. Fig.
  • Page 8: Operation

    OPERATION STEP 1. STEP 2. Operating instructions for manual Mode setting for Sensor Models models (Fig. 17) (Fig. 18) Press the lever to dispense the soap or Dispensing times can be adjusted to any sanitizer onto hands. of three modes. 1.
  • Page 9: Maintenance

    MAINTENANCE STEP 1. Fig. 18 Mode switch cover Cleaning the unit body To ensure longevity, carry out periodic maintenance. For standard cleaning, wipe off dirt with soft, dry cloth. For dispensers that are very dirty, wipe with a wet, soapy cloth. DO NOT USE: Thinner, benzene, alcohol, petroleum, powder soap, polishing powder, detergent other than neutral detergent,...
  • Page 10: Maintenance

    MAINTENANCE STEP 3. Fig. 20 Cleaning the nozzle of Manual Models (Fig. 20) A clogged nozzle may result in poor dispensing or malfunction. To clean the nozzle: Nozzle Soap 1. Open the cover and clear the Thin wire pin/ dispensing hole at the end of the paperclip nozzle with a thin wire pin (less than 0.5 mm) –...
  • Page 11: Troubleshooting

    TROUBLESHOOTING EMERGENCY MEASURES Before calling for repair of Take emergency measures listed on pouch Sensor Models label according to chemical being used. Problem: The unit does not operate Eye contact: Flush eyes with water for a 1. Check if the unit is securely closed minimum of 15 minutes and consult a 2.
  • Page 12 The information contained in this document is subject to change without notice. Air Delights, Inc. 9974 SW Arctic Drive Beaverton, Or. 97005 Phone: 800-440-5556 Fax: 503-643-8224 www.sloanvalve.com ©2009 Sloan Valve Company Printed in the U.S.A. JSD6031.1 01/09...

This manual is also suitable for:

Soap/sanitizer dispensers

Table of Contents