Advertisement
Quick Links
INSTALLATION INSTRUCTIONS FOR DECK MOUNT
SENSOR ACTIVATED SOAP DISPENSER
Sloan Valve Company warrants its SJS-1650 Electronic Soap Dispenser to be made of first class materials, free from defects of material or
workmanship under normal use and to perform the service for which it is intended in a thoroughly reliable and efficient manner when properly
installed and serviced, for a period of three years (1 year for special finishes) from date of purchase. During this period, Sloan Valve Company
will, at its option, repair or replace any part or parts which prove to be thus defective if returned to Sloan Valve Company, at customer's cost, and
this shall be the sole remedy available under this warranty. No claims will be allowed for labor, transportation or other incidental costs. This
warranty extends only to persons or organizations who purchase Sloan Valve Company's products directly from Sloan Valve Company for purpose
of resale. This warranty does not cover the life of the batteries.
THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF. IN NO EVENT IS SLOAN VALVE COMPANY
RESPONSIBLE FOR ANY CONSEQUENTIAL DAMAGES OF ANY MEASURE WHATSOEVER.
ROUGH-IN
For Soap Replenishment, use:
Sloan Part #
• SJS-1651-3 — Liquid Soap
• SJS-1651-4 — Liquid Soap w/Moisturizers
LIMITED WARRANTY
Direct Connect
Installation
SJS-1650
Sensor Activated
Soap Dispenser
Description
Offset
Installation
PRIOR TO INSTALLATION
New Soap Dispenser Installation:
• Locate position of dispenser using templates shown
in rough-in diagrams (refer to rough-in diagrams
below)
• Ensure that dispenser does not interfere with anything
above or below the lavatory/counter top area
• Drill a 1" diameter hole in counter top
• Clean area around hole
Replacing Existing Soap Dispenser:
• Remove old components
• Clean area around hole
• Ensure hole is 1" to 1-1/4" diameter
LOCATION
The SJS-1650 Soap Dispenser is designed to be
mounted to the left or right of the faucet as shown below.
When choosing a location, make sure that there will be
accessibility to the unit on the underside of the sink (the
Motor and Soap Container cannot interfere with the water
or drain lines).
Advertisement
Related Manuals for Sloan SJS-1650
Summary of Contents for Sloan SJS-1650
- Page 1 (1 year for special finishes) from date of purchase. During this period, Sloan Valve Company will, at its option, repair or replace any part or parts which prove to be thus defective if returned to Sloan Valve Company, at customer’s cost, and this shall be the sole remedy available under this warranty.
- Page 2 Install Spout Mount Motor Assembly !!! IMPORTANT !!! Choose a location where there will be accessibility to the unit on the underside of the sink (the Motor and Soap Container cannot interfere with the water or drain lines). Before drilling holes in the wall, be sure that no other Slide Rubber Gasket onto pipes or wires exist.
- Page 3 Mount Battery Compartment Attach Tubes to Motor Assembly Note: Before mounting, make certain power cord will reach Motor Assembly Connection. EXTENSION TUBE Insert male end of Extension Using the Battery Compartment as a template, mark Tube into Motor Assembly and the mounting holes on wall.
- Page 4 The information contained in this document is subject to change without notice. A. Tighten the existing flange nut on the shank of the spout under the counter. B. Add a second flange nut from Sloan to act as a jam nut in conjunction with the nut already installed.
Need help?
Do you have a question about the SJS-1650 and is the answer not in the manual?
Questions and answers