Radio Frequency Programming - Perimeter PCC-100 Owner's Manual

Owner's Guide
and is ready to be programmed. Press and
release the bottom button marked SET on
the wall transmitter.
The collar receiver light will fl ash the
number corresponding to the level you
have selected. When programming is
complete the transmitter will return auto-
matically to normal operation.

Radio Frequency Programming

This programming option allows the user
to switch the operating frequency from 7
kHz to 4 kHz in the unlikely case of signal
interference from sources such as neigh-
boring pet fencing systems. Your system
has come preset from the factory on 7 kHz
where you are most likely not to encoun-
ter interference issues.
To change your frequency settings:
STEP 1 – Press
and hold both
the top and
bottom but-
tons marked
SCROLL and
SET on the wall
transmitter
simultaneously
for 6 seconds. The transmitter display will
fi rst show "00" for three seconds, con-
tinue to press both buttons for an another
3 seconds to enter frequency mode. Either
"01" or "02" will be displayed on the wall
mount transmitter.
STEP 2
– Release both
transmitter
buttons. Press
and release the
SCROLL button
10
PCC-100 & PCC-200
to select desired frequency settings. The
transmitter display will show correspond-
ing number with each button push.
STEP 3 – Hold
the pet fence
collar receiver
against the
wall mount
transmitter.
The collar
receiver light
will illuminate
and is ready to be programmed. Press and
release the button marked SET on the wall
transmitter.
The collar receiver light will fl ash the
number corresponding to the level you
have selected. When programming is
complete the transmitter will return auto-
SCROLL
matically to normal operation.
SET
PLEASE NOTE: The only user-adjustable
feature available for the PCC-100 is the
signal fi eld width.
SCROLL
SET
Settings
01 = 7 kHz
02 = 4 kHz
SCROLL
SET