Advertisement
▪ Back power Switch and Front LED Indicators
1) power LED Indicator: Illuminates red when power cord is plugged in and
power switch on back of unit is turned on.
2) Charging LED Indicator: Illuminates orange when in charge mode and
changes to green when battery charging is complete. If the Charging LED
Indicator remains orange after a 10 hour period switch the charger OFF and
remove the battery connections. Insure the battery polarity is correct, and if so,
replace the battery.
3) power Switch: (on back) Power is ON when switched to "I" and OFF when
switched to "O"
Charging LED
4) Fuse holder: Contains a 10A fuse in case of overload.
Power LED
▪ Operation
The HF Charger Series has been designed to provide fully automatic recharging of most 12V, 14V or 16V maintenance
free, deep-cycle, AGM and gel-cell batteries. If possible, disconnect all loads from the battery by removing battery cables,
opening a disconnect switch, or switching loads off.
To charge your 12V, 14V or 16V battery:
1) With the charger's power switch in the OFF position plug the charger into a grounded wall receptacle.
2) Connect the red positive (+) clip of the charger cables to the positive (+) terminal of the vehicle battery.
3) Connect the black negative (–) clip of the charger cables to a solid chassis ground. If this is not possible, connect
it to the negative (–) battery terminal.
4) Flip the power switch on the back panel to ON. The power LED will illuminate red while the microprocessors
analyze the battery and after a short delay, the Charging LED Indicator on the front panel will illuminate orange,
beginning the three-stage charging sequence.
*Note that the charger will automatically restart the charging sequence if the charge current
rises above a factory preset threshold.
9) When complete, the Charging LED Indicator will turn green, flip the power switch to OFF.
10) Remove the black negative (–) clip and the red positive (+) clip from the vehicle's battery terminals.
Advertisement
