Related Manuals for Guest 503A BEAMER
Summary of Contents for Guest 503A BEAMER
- Page 1 MODEL 503A BEAMER REMOTE CONTROL SPOT/FLOOD LIGHT INSTALLATION AND OPERATION INSTRUCTIONS IMPORTANT ! READ THESE INSTRUCTIONS BEFORE INSTALLING AND USING THIS PRODUCT. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE 730372...
- Page 2 1 mile away or the 55 watt wide-area floodlight for docking and deck lighting. All Guest Beamer spotlights can rotate 355° and move up and down through an 80° arc. Although the model 503A cannot be upgraded for wireless control, multiple control panels can be installed using the 728830-P dual station control.
-
Page 3: Installation
Installation Mounting the Spotlight 1. Select a horizontal , smooth surface to mount the spot/flood light on. Be sure you will have access to the underside of the chosen location, and that you will be able to drill holes there without damaging existing wiring or structures. - Page 4 Tighten the nuts enough to slightly compress the small gasket. Electrical Connections The Guest Model 503 spot/flood light has two types of wiring connections. They are: Power supply wires - the larger red (+) and black (−) wires that bring 12 volts DC power to •...
- Page 5 Control cable wires - the small wires within a gray casing that carry your commands from • the control panel to the spot/flood light. CAUTION! DO NOT CONNECT THE CONTROL WIRES (with connectors) TO ANY SUPPLY WIRES. DO NOT REVERSE THE RED (POSITIVE) AND BLACK (NEGATIVE) POWER WIRES. This spot/flood light requires a source of 12 volt DC power that is capable of supplying 10 amps of current even when other equipment is operating.
-
Page 6: Operation
Operation To move the spotlight, press one of the directional switches firmly. By pressing a horizontal switch and a vertical switch together, the light will move both vertically and horizontally at the same time. Pressing the Green center switch once will activate the 100 watt spotlight beam. Pressing the same switch 2 or 4 times will turn off all lights. -
Page 7: Troubleshooting
If there are no loose wires or signs of water penetration, re-install the spotlight and then replace the control pad. If there signs of water damage, return the spotlight and control to the Guest Co. Service Department for repair, include information about how and where the spotlight was installed. - Page 8 LIMITED WARRANTY For one (1) year from the date of original purchase, The Guest Co. will, at its discretion, repair or replace for the original consumer, free of charge, any parts found defective in material or workmanship. All transportation charges under this warranty must be borne by the consumer.