Related Manuals for Guest 500A BEAMER
Summary of Contents for Guest 500A BEAMER
- Page 1 MODEL 500A BEAMER REMOTE CONTROL SPOTLIGHT INSTALLATION AND OPERATION INSTRUCTIONS IMPORTANT ! READ THESE INSTRUCTIONS BEFORE INSTALLING AND USING THIS PRODUCT. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE...
- Page 2 The penetrating 100-watt beam can illuminate objects up to one (1) mile away. All Guest Beamer spotlights can rotate 355° and move up and down through an 80° arc. Although the model 500A cannot be upgraded for wireless control, multiple control panels can be installed using the 729824-P dual station control.
-
Page 3: Installation
You will also need marine grade stranded, 2-conductor, 12- gauge wire to connect the spotlight and the control panel to 12-volt DC power sources. (Use 10-gauge wire if the light will be more than 30 feet (9mm) from its power source.) Installation Mounting the Spotlight 1. - Page 4 7. Place the light on the mounting surface, lens facing forward, and align the 4 holes in the light base and the foam gasket with the 4 corner holes drilled into the mounting surface. 8. Fasten the spotlight securely to the mounting surface using four 1/4" (6mm) bolts, flat washers, lock washers and nuts (not included).
- Page 5 Tighten the nuts enough to slightly compress the small gasket. Electrical Connections The Guest Model 500A Spotlight has two types of wiring connections. They are: Power supply wires - the larger red (+) and black (−) wires that bring 12 volts DC •...
-
Page 6: Operation
results use waterproof telephone splices or solder the wire connections, and then cover them with heat-shrink tubing. This spot/flood light requires a source of 12 volt DC power that is capable of supplying 10 amps of current even when other equipment is operating. For best results, run two new wires from the red (+) positive and black (−) negative power wires of the light directly to the main 12 volt DC accessory panel. -
Page 7: Maintenance
Under normal conditions, mild detergent and water will be sufficient to keep the spotlight clean. Avoid using caustic chemicals or abrasives as they may damage the housing. No lubrication is necessary. For replacement parts you can call the Guest Co. at 203-235-4421 or contact your local dealer. Item... -
Page 8: Troubleshooting
D-23127 Gasket For Control Panel 729962 NOTE: THE CONTROL PANELS USED WITH GUEST MODELS 501A, 502A, OR 503A WILL NOT OPERATE THE MODEL 500A SPOTLIGHT. Troubleshooting Under normal use, your Guest Beamer spotlight will provide you with many years of reliable service. - Page 9 Service Department for assistance at (203) 235-4421. LIMITED WARRANTY For one (1) year from the date of original purchase, The Guest Co. will, at its discretion, repair or replace for the original consumer, free of charge, any parts found defective in material or workmanship. All transportation charges under this warranty must be borne by the consumer.
- Page 10 This is the exclusive remedy and consequential damages are excluded where permitted by law. The Guest Co. 95 Research Parkway Meriden, CT 06450, USA Tel: (203) 235-4421 Email: info@guestco.com Fax: (203) 235-0039 Website: www.guestco.com 730385 REV A...