First Alert FA260RF Installation Instructions Manual page 4

Defaulting the FA260RF
To restore the FA260RF to the default values, perform the following steps:
Step Action
1 Enter the Program mode by pressing the [1] and [3] keys simultaneously for a few seconds within 30
seconds after applying power. The keypad alternately flashes "00" and two dashes.
2 Press the [9] key. The display flashes "EE."
3 Press the [1] key to restore the default values, or press any other key to exit without restoring the
default values.
If you pressed [1], the keypad beeps 3 times and returns to alternately flashing "00" and two dashes.
If you pressed any other key, the keypad does not beep, and returns to alternately flashing "00" and
two dashes.
4
Press [ ] to exit the FA260RF Program Mode.
Programming Procedure
This section is divided into two parts.
•
Programming for an installation WITHOUT local wireless keys.
•
Programming for an installation WITH local wireless keys.
Using this programming procedure is necessary only if you plan to use wireless keys beyond the control
panel's capacity, or on a system that does not support 5800 Series wireless. Refer to the FA260RF
Application Guide on page 2 for installations that require these settings.
Note: See the control panel's installation instructions for the acceptable keypad and receiver addresses.
•
If you are using a wireless key in High-Security mode (5804E) in the control panel, it will occupy one
of the devices in the FA260RF.
•
When operating the system in High-Security mode, non-encrypted wireless keys will still function. If
you want only the encrypted keys to operate, be sure to delete all non-encrypted keys from the
system.
Programming for an Installation WITHOUT Local Wireless Keys
To program the FA260RF for an installation without any local wireless keys, perform the following steps:
Step Action
1 Enter the Program mode by pressing the [1] and [3] keys
simultaneously for a few seconds within 30 seconds after applying
power or within 30 seconds after removing the case back.
2 Enter [1] (Keypad Address). Enter the 2-digit keypad address (01-
31). Press the [ ] key to continue.
3 Enter [2] (Receiver Address). Enter the 2-digit receiver address (00-
30). Press the [ ] key to continue.
Enter [4] (House ID Source). Enter [1] (System) to use the House ID
4
programmed into the control panel, if RF keypad(s) and/or bi-
directional device(s):
•
Are used on the control panel.
•
Neither is used.
Enter [0] (Local) to use the House ID programmed into the
FA260RF (Program Address 3).
Note: If the House ID Source is:
• System (1), RF keypad and bi-directional units MUST
• Local (0), RF keypad and bi-directional units MUST
Press the [ ] key to continue.
4
OR
match the House ID programmed into the control panel.
match the House ID programmed into the FA260RF.
Display
Alternately flashes "oo" and
two dashes.
Alternately flashes "cA" and
the 2-digit keypad address.
Alternately flashes "rA" and
the 2-digit receiver address.
Alternately flashes "hl" and
either "1" or "0."