Sony RDR-HXD890 Operating Instructions Manual page 127

, Video signals from the LINE 1 jack appear
in standby mode when connecting your TV
to the LINE 3 – TV jack. This is not a
malfunction.
In this case, reconnect your TV to the
LINE 2 OUT jacks, or turn off the
equipment connected to the LINE 1 jack.
There is no picture or picture noise
appears when connected to the DV IN
jack.
, Try the following: 1Turn the recorder off
and on again. 2Turn the connected
equipment off and on again. 3Disconnect
and then connect the i.LINK cable again.
There is no picture or picture noise appears
when connected to the HDMI OUT jack.
, Try the following: 1Turn the recorder off
and on again. 2Turn the connected
equipment off and on again. 3Disconnect
and then connect the HDMI cord again.
, If the HDMI OUT jack is used for video
output, changing the "Screen Resolution"
setting in the "HDMI Output" setup may
solve the problem (page 121). Connect the
TV and the recorder using a video jack
other than HDMI OUT, and switch the
TV's input to the connected video input so
that you can see the on-screen displays.
Change the "Screen Resolution" setting in
the "HDMI Output" setup, and switch the
TV's input back to HDMI. If the picture
still does not appear, repeat the steps and
try other options.
, The recorder is connected to an input
device that is not HDCP compliant
(page 19).
, When picture noise appears after you
change the "Screen Resolution" setting,
hold down x (stop) on the recorder, and
press Z (open/close) on the recorder.
TV programme reception does not fill the
screen.
, Set the channel manually in "Manual CH
Setting" in the "Analog Tuner" setup
(page 110).
, Select the correct source using the INPUT
button, or select a channel of any TV
programme using the PROG +/– buttons.
The picture is breaking up.
, The signal strength is low.
, Check aerial installation.
TV programme pictures are distorted.
, Reorient the TV aerial.
, Adjust the picture (refer to the TV's
instruction manual).
, Place the recorder and TV farther apart.
, Place the TV and any bunched aerial
cables farther apart.
, The aerial cable is connected to the
AERIAL OUT jack on the recorder.
Connect the cable to the AERIAL IN jack.
, The recorder's colour system is different
from your TV. Hold down x (stop) on the
recorder, and press INPUT on the recorder
to change the recorder's colour system.
TV channels cannot be changed.
, A timer recording started, which changed
the channels.
, The channel is skipped (page 110).
, The Parental Lock is activated (page 120).
The picture from equipment connected to
the recorder's input jack does not appear
on the screen.
, If the equipment is connected to the LINE
1 jack, select "L1" in the front panel
display by pressing INPUT.
If the equipment is connected to the LINE
2 IN jacks, select "L2" in the front panel
display by pressing INPUT.
The playback picture or TV programme
from the equipment connected through
the recorder is distorted.
, If the playback picture output from a DVD
player, VCR, or tuner goes through your
recorder before reaching your TV, the
copy-protection signal applied to some
programmes could affect picture quality.
Disconnect the playback equipment in
question and connect it directly to your
TV.
The picture does not fill the screen.
, Set "TV Type" in the "Playback" setup in
accordance with the screen size of your TV
(page 119).
127
,continued