Advertisement
CAUTION: Use care when tightening the nut to avoid damaging the rubber boot.
3.
Cable Connector
Control head
CAUTION: The slot for the connector is keyed to prevent reversed installation, so do not force the connector into the holder.
See the Installation section of your operations manual for additional information.
4.
CAUTION! Do not cut or shorten the transducer cable, and try not to damage the cable insulation. Route the cable as far as
possible from any VHF radio antenna cables or tachometer cables to reduce the possibility of interference. If the cable is too
short, extension cables are available to extend the transducer cable up to a total of 50'. For assistance, contact the Customer
Resource Center at www.humminbird.com or call 1-800-633-1468 for more information.
Unit 1
Unit 2
US2 W Switch
Cable Connector
Route connector to
the transducer
Control head
2
Unit Switch
Cable Connector
Advertisement
