Assembly And Adjustments; In The Box; Items Included - Tool Shop 10” 15 AMP COMPOUND MITER SAW Operator's Manual

ITEMS INCLUDED

• Miter Saw
• Hex Wrench
• Material Clamp
• Dust Bag
• Dual Material Extensions
• Stability Bar
Assembly
A. Setting up the saw (Fig. 1 & 2)
• Insert the two table extensions (12) into the mounts (26) provided on the side and fasten them in place
with fasteners (27).
• Insert the clamping device (18) into one of the two receptacles (19) provided on top of stop rail and
fasten in place with the thumb screw (28).
• Attach the rear stability bar (23) to the back of the machine.
B. Adjusting the saw (Fig. # 1 & 3)
• To adjust the miter table (8), grab hold of miter table knob (10) and move to desired degree on miter
scale (16) .
• The miter scale (16) has latching detente positions at 0o, 15°, 22.5o, 30o and 45o.
• Press down lightly on the handle (2), pull the retaining pin (15) out of the motor holder to disengage
the saw from its bottom locked position.
• Raise the machine head (4) to the top working position.
• By adjusting the bevel lock lever (11), the machine head (4) can be beveled to the left up to 45o.
• Make sure the main voltage is compatible with your power source.

Assembly and Adjustments

Figure 9
21
20
13
25
12 12
Figure 3
10
16
9
18
23