Advertisement
1000A
Basic 2 – way mode
1. L&R Line In
Connect signal leads from your mixer
(master left/right, line out, to the balanced
inputs using XLR mic lead or unbalanced
phono connectors. XLR connectors to be wired
as follows:1 ground, 2 +, 3 -. Unbalanced
Phono leads pin1 ground and shorted to pin 3-,
pin 2 tip. Balanced Phono leads can be wired
Sleeve pin 1 ground, Ring pin 3-, and tip pin 2
2. L&R Line Through
Use this Male XLR parallel output to route the
incoming line signal to other line level inputs
such as powered speakers or into Aux 1&2
inputs for alternative set-up configurations.
7. Sub Bass volume
Volume control for internal 650 watt Sub bass
amplifier. When used in conjunction with the
Master L&R input, a balance between the
low frequencies of the sub bass and the mid
high output from the satellite speakers can be
optimised for the venue and the music source.
6
User Manual
Independant Satellite mode
3. Aux 1&2 inputs
Input to Satellite amplifiers when in Aux mode.
4. L & R input volume control
When Aux is engaged L + R input volume
controls drive Satellite amplifiers outputs from
Aux inputs.
8. HF cut
This control can be used to change the bass
crossover frequency from 80 Hz to 200 Hz.
For best sub bass response select 80 – 100Hz.
Hide quick links:
Advertisement
