ICS Nav6 Plus User Manual page 29

Nav6 Plus Navtex System User Guide
Set the filter for each station to one of the following:
Setting
On
Off
Auto
Setup Mode, Navtex View, 518 and 490 Names Pages Setup Mode, Navtex View, 518 and 490 Names Pages Setup Mode, Navtex View, 518 and 490 Names Pages Setup Mode, Navtex View, 518 and 490 Names Pages
The station names setup pages
determine the names of stations
displayed on station filter pages and
in Navtex message headers.
The picture shows the '518 Names'
page; the '490 Names' page is
similar.
Use the UP and DOWN keys to
select the setting that you wish to
edit. Use the LEFT and RIGHT keys
to change the setting.
The Station Name Selection setting allows the user to select
between 'GPS' and 'Manual' station selection. If 'GPS' is selected
and there is valid position data on the NMEA input, the Nav6 will
select the NAVTEX transmitting station name nearest to the boat's
current location for each station letter.
If 'Manual' is selected, then the user can manually select the
transmitting station name to be displayed for each station letter.
(Tip : You may be sailing in Nav Area II and therefore will pick station
names from Nav Area II. However it is important to realise that the
corresponding station letter in the adjacent Nav Areas may be
closer. For example, the 'S' station that you are receiving is the 'S'
station in an adjacent Nav Area).
Notes
Messages from station always printed
Messages from station never printed
Messages from station printed only when nearest or in
range depending upon setting.
29