Unpacking The System; Setting Up The Amplifier - New Focus TA-7600 Series User Manual

Figure 3 Rear Panel power input port and fuse bay.
TA-7600 Operation
Introduction
This section outlines the basic steps needed to set up and use your TA-7600 series amplifier system.

Unpacking the System

Carefully unpack the TA-7600 series amplifier system. Compare the contents against the packing slip
and inspect them for any signs of damage. If parts are missing or you notice any signs of damage,
such as dented or scratched covers, please contact Newport immediately. Save the shipping container
and packing material for future shipping needs.

Setting up the Amplifier

1. Mount the amplifier head: The amplifier head is shipped with a mounting bracket already
attached. This bracket also serves as a heatsink to avoid overheating the amplifier head.
Mount the amplifier head/bracket in a stable position with the output aperture pointing
towards an appropriate beam block. Output-beam height is two inches for the free-space
models.
2. Position the controller: Position the controller within a cable length of the amplifier head
(about five feet). The controller keyswitch should be off (fully counter-clockwise). Be
careful position the controller in such a way that it will be easy to access the on/off switch
on the rear of the device as well as the key switch on the front. Also position the
controller in such a way that it is easy to remove the head plug cable.
3. Connect the head and controller: Connect the controller to the amplifier head with the
26-pin D-connector amplifier cable provided. Use only the supplied New Focus
amplifier cable to connect the controller to the amplifier head. To ensure proper and safe
operation of the amplifier, secure the cable to the amplifier head and controller using the
- 7 -