Install The Range; Level The Range - GE JCBP65 Owner's Manual And Installation Instructions

INSTALL THE RANGE

2 ANTI-TIP DEVICE INSTALLATION
An Anti-Tip bracket is supplied with instructions
for installation in a variety of locations. The
instructions include all necessary information
to complete the installation. Read the Safety
Instructions and the instructions that fit your
situation before beginning installation.
Screw must
enter wood
or metal
Typical installation of anti-tip bracket attachment to wall
WARNING —
• Range must be secured by Anti-Tip bracket
supplied.
• If the Anti-Tip device supplied with the
range does not fit this application, use the
universal Anti-Tip device WB2X7909.
• See instructions to install (supplied with
bracket).
• Unless properly installed, the range could
be tipped by stepping or sitting on the door.
Injury may result from spilled hot liquids
or from the range itself.
REMOVE STORAGE DRAWER
3
Pull the drawer out until it stops.
A
Lift the front of the drawer until the
B
stops clear the guide.
Remove the drawer.
C
Installation Instructions
Wall plate
Bracket
Stop
4

LEVEL THE RANGE

A Install the oven racks in the oven
and position the range where it will
be installed.
Check for levelness by
B
placing a spirit level or
a cup, partially filled
with water, on one of
the oven racks. If using
a spirit level, take two
readings—with the level
placed diagonally first in
one direction and then the other.
The front leveling legs can be adjusted
C
from the bottom and the rear legs can be
adjusted from the top or the bottom.
Leg
leveler
Raise
range
Use an open-end or adjustable wrench
D
to adjust the leveling legs until the range
is level.
REPLACE THE STORAGE
5
DRAWER
Place the drawer rail on the guides.
A
B Push the drawer in until it stops.
Lift the front of the drawer and push in
C
until the stops clear the guides.
D Lower the front of the drawer and push in
until it closes.
30
Spirit level
Lower
range
Stop