GE JCBS55 Owner's Manual And Installation Instructions page 19

Hinge lock
Slot
(unlocked
position)
Hinge arm
Removal position
Oven rack
Lift-Off Oven Door
The door is very heavy. Be careful when
removing and lifting the door.
Do not lift the door by the handle.
To remove the door:
Fully open the door.
Push the hinge locks down toward
the door frame, to the unlocked
position. This may require a
flat-blade screwdriver.
Close door to the door removal
position.
Firmly grasp both sides of the door
at the top.
Lift door up until the hinge arm is
clear of the slot.
Oven Racks
Clean with an abrasive cleanser or steel
wool. After cleaning, rinse the racks with
clean water and dry with a clean cloth.
Stainless Steel Surfaces
Do not use a steel wool pad; it will scratch
the surface.
To clean the stainless steel surface, use
warm sudsy water or a stainless steel
cleaner or polish. Always wipe the surface
in the direction of the grain. Follow the
cleaner instructions for cleaning the
stainless steel surface.
Painted Surfaces
Painted surfaces include the sides,
top of the control panel and the drawer
front. Clean these with soap and water
or a vinegar and water solution.
To replace the door:
Firmly grasp
both sides of
the door at
the top, with
the door at the
same angle as the
removal position.
Seat the indentation
on the bottom of the hinge arm into
the bottom edge of the hinge slot.
Fully open the door.
Push the hinge locks up against the
front frame of the oven cavity to the
locked position.
Locked
Position
Seated
Hinge Arm
Close the oven door.
To make the racks slide more easily,
apply a small amount of vegetable oil
to a paper towel and wipe the edges
of the oven racks with the paper towel.
Do not spray with Pam
lubricant sprays.
(on some models)
To inquire about purchasing stainless
steel appliance cleaner or polish, or to
find the location of a dealer or Camco
Parts Store nearest you, please call our
toll-free number:
National Parts Center
www.GEAppliances.ca
Do not use commercial oven cleaners,
cleaning powders, steel wool or harsh
abrasives on any painted surface.
www.GEAppliances.ca
Bottom
Hinge arm
edge
of slot
Indentation
® or other
1.800.661.1616
19