Table of Contents
Summary of Contents for ultra finishing AX310
- Page 1 AX310 / AX311 Shower Handbook IMPORTANT: Please retain this booklet for future reference We offer a technical advisory service on the telephone to contractors and other customers with problems in the field RING 0844 372 7766...
-
Page 2: Table Of Contents
CONTENTS Page How to use your shower …………… How your shower works …………… What to do if things go wrong …………… Installation instructions …………..How to maintain your shower …………… Guarantee …………… Diagram 1 How to use your shower 1. Ensure the electricity and water are turned on to the unit 2. -
Page 3: How Your Shower Works
After Sales Service We offer a technical advisory service to contractors and other customers with problems in the field. RING: 0844 372 7766 or FAX: 0844 372 7767 Spare parts can be supplied against any debit or credit cards. RING: 0844 372 7750 or FAX: 0844 3737760 Remember to quote the exact type of shower, as written on the front face. - Page 4 3. The heaters are only switched on when sufficient water is flowing. This is done automatically with a switch, which works on water pressure. 4. The water is turned on and off by the solenoid valve built into the shower. This is switched on by button ‘A’, ‘B’...
-
Page 5: What To Do If Things Go Wrong
What to do if things go wrong SELF HELP If the shower is not working satisfactorily, make the following checks before calling out the contractor. Any of these adjustments could restore the performance a) The shower The shower temperature is set too hot causing the thermal cut-out cycles from HOT (safety device) to operate. -
Page 6: Installation Instructions
Installation instructions Check that the electrical rating shown on the showers matches the mains supply. A competent installer must undertake all installations. If in any doubt, advice and assistance should be sought from a qualified plumber and/or electrician. Installations and wiring must conform to current BS7671 (IEE regulations - UK) and “Part P”... - Page 7 7. If you have not yet done so, remove the front cover (complete with control knob) of the unit by undoing the retaining screws at the top and bottom of the unit and lifting the cover off. The top-fixing hole is a keyhole slot, and should be marked and drilled first.
- Page 8 Diagram 9 6. With the stop valve connected, flush the pipe-work through to remove any particles etc., before making the final connection to the shower. Blockage in the waterways (particularly the handset and solenoid valve) will prevent the heater working properly. 7.
- Page 9 WARNING - FAILURE TO COMPLY WITH THESE INSTRUCTIONS COULD RESULT IN A FAILURE OF THE TERMINAL BLOCK AND CABLING. 5. WARNING - THIS APPLIANCE MUST BE EARTHED. 6. Ensure that the removable side section is fitted securely into the back-plate. 7.
-
Page 10: How To Maintain Your Shower
How to maintain your shower It is recommended that the shower unit, riser rail, hose etc. can be cleaned using a soft cloth and that the use of an abrasive or solvent based cleaning fluid be avoided. This is especially the case on any plated finishes. - Page 11 Diagram 13...
-
Page 12: Guarantee
Manufactured in England for:- ULTRA FINISHING LIMITED WIDOW HILL ROAD, HEASANDFORD INDUSTRIAL ESTATE, BURNLEY, LANCS, BB10 2BE TEL: 01282 436934 / FAX: 01282 428915 Technical Advice Line: 0844 372 7766 Website: www.ultra-group.co.uk (A4 Leaflet No. 555-2066-47A)