Putting Into Operation; Use In Accordance With Purpose - Marks & Spencer T68 Instruction Manual

Protect the outer kettle and the 360° power
●
base from damp. never put them into the
dishwasher! never immerse them in
water!
Do not use the connecting cable to pull on the
●
plug nor remove the plug from the socket with
wet hands! Never immerse it in water!
CAUTION!
Please observe the following safety instructions to
avoid damages and risks attributable to improper
use:
Neither the appliance nor the 360° power base
●
can be opened.
Always remove the kettle from the 360°
●
power base and allow it to cool down if faults
occur during operation or for cleaning and
maintenance! Disconnect the plug from the
mains!
Observe the instructions for de-scaling!
●

use in accordance with purpose

The appliance may only be used to heat and boil
water. never put milk, soup, coffee or tea,
etc., into the kettle.
No liability is accepted for any damage resulting
from use for other purposes, faulty operation or
amateur repairs. Guarantee services are also
excluded in such cases. the appliance is not
intended for professional purposes!
This appliance is intended to be used in household
and similar applications such as:
staff kitchen areas in shops, offices and other
●
working environments
farm houses
●
by clients in hotels, motels and other
●
residential type environments
bed and breakfast type environments
●
MS 1.7 Litre Black Kettle User G8 8
1.7 Litre Kettle
operating the appliance for the
first time
FIG. 1
Before using the kettle for the first time, fill it up to the
maximum level 1.7 litres, and boil at least two lots of
water. Rinse the kettle out with cold water each time
between boiling up these two lots of water.
Method:
Adjust the required length of cable on the 360°
●
power base "f". Wind any cable not required
underneath the 360° power base (1).
Connect the 360° power base "f" according to
●
instructions (observe the safety instructions).
Put the appliance into operation (see "Putting
●
into operation").

Putting into operation

FIG. 2 – 7
Filling with water
Open the kettle lid "a" with the lid release button
●
"b" and fill the kettle while the lid is open ().
Check the filling level on the water level gauge
●
"e". Note the maxi mum filling level ()!
Note!
If the kettle was accidentally switched on when
empty, the safety cutout will automatically
switch it off. In this case you should remove
the kettle from the 360° power base and allow
it to cool down for a few minutes. Make sure
that the kettle has been filled with an adequate
amount of water before using it again.

20/7/12 10:32:50