Back Panel - Schiit Gungnir adapticlock SCH-06 Owner's Manual

BACK PANEL

sE OUTs
1
1 RCA Single-Ended 2 XLR Balanced
Outputs. If you don't Outputs. If the rest of
have balanced con- your gear is balanced,
nections, use these to use XLR cables to
connect to your amp or connect Gungnir to
preamp. We've provided their inputs from these
two pairs for your outputs.
convenience. There's
3 BNC Input. If you have
no difference between
a source with a BNC
them.
digital output, Gungnir
provides a true 75 ohm
BNC input for highest-
quality data transmission.
Connect this input with a
true 75-ohm BNC cable.
bal OUT
balanced DAC
fully upgradable
ADAPTICLOCk™
discrete analog
NO USER SERVICEABLE PARTS INSIDE
2
4 Coaxial Input.
Connect your coaxial
output source with . . .
wait for it . . . a coaxial
cable! Very exciting.
5 Optical Input. Use a
standard Toslink cable
to connect to the optical
input. If you're using an
Apple computer with
integrated optical output,
you'll need a Toslink with
a 1/8" (3.5mm) plug on
one side, and a standard
Toslink on the other.
6
digital inputs
SCH06J
000001
230VAC 20W
4 5
6 USB Input. Or not. If
you don't have the USB
card installed, this input
will be covered. If you
do, use a standard USB
A-B cable to connect.
7 Power Switch. Up
is on. Down is off. It
doesn't go sideways.
caution: risk of electric
shock— do not open.
no user serviceable
parts inside
3 7
8 AC Input. Plug the
power cord in here. Plug
the other end into a wall
outlet of the correct volt-
age. Trying to run a 115V
unit on 230V will result in
a blown fuse, no music,
and a void warranty.
8