Tubes Installation; Tube Biasing - CANARY AUDIO CA-300 Owner's Manual

TUBES INSTALLATION

The placement of the vacuum tubes for the CA-300 are to be placed in the exact
socket as shown in Diagram 1.1.
When placing a tube in the appropriate socket be careful not to force the tube,
make sure the pins are lined up carefully with the socket, then proceed to seat the
tube into the socket with a gentle rocking motion.
Be careful to identify each tubes particular placement, for each tube corresponds
with a particular socket.
After the placement of all the tubes, be sure to allow your amplifier to warm up for
one minute before each use.

TUBE BIASING

The CA-300 mono blocks amplifier is auto biasing. There is no need to adjust the
bias voltage for the power tube used in this amplifier.
5U4G 300B
6SL7
Diagram 1.1 Overview of CA-300