Subscribe to Our Youtube Channel
Related Manuals for Sterling Forge 720-0322
Summary of Contents for Sterling Forge 720-0322
- Page 1 Essential Element for Outdoor Entertainment Stainless Steel Gas Grill USE AND CARE GUIDE MODEL NO.: 720-0322 Sterling Forge: SKU# SF2456 FOR OUTDOOR USE ONLY CUSTOMER SERVICE: www.sterlingforgegrills.com...
-
Page 2: Table Of Contents
TABLE OF CONTENTS SECTION ONE: Table of Contents & SECTION FIVE: Importance-----------------------------1 Care & Maintenance-----------------22 Precautions-----------------------------2-5 SECTION SIX: Exploded View------------------------23 SECTION TWO: Parts List-------------------------------24 Assembly Instructions----------------6-13 Gas holder & propane tank assembly SECTION SEVEN: -------------------------------------------14 Trouble Shooting---------------------25 To match light the grill---------------15 SECTION EIGHT: SECTION THREE: Grilling Hints--------------------------26... - Page 3 PRECAUTIONS WARNING CAUTION: Beware of Flash-back Do not try lighting this appliance without reading the “LIGHTING INSTRUCTIONS” section of this CAUTION: Spiders and small insects manual. occasionally spin webs or make nests in the grill burner tubes during transit and warehousing. Grill Installation Codes These webs can lead to gas flow obstruction, The installation must conform with local codes...
-
Page 4: Precautions
PRECAUTIONS LP-Gas Supply System PROPER PLACEMENT AND CLEARANCE OF GRILL • Never use your gas grill in a garage, porch, shed, breezeway or any other enclosed area. Your gas grill is to be used outdoors only. Minimum clearance from sides and back of unit to combustible construction, 24 inches (61cm) from sides and 24 inches (61cm) from back. - Page 5 PRECAUTIONS WARNING SAFETY PRACTICES TO AVOID PERSONAL Your grill will get very hot. Never lean over the INJURY cooking area while using your grill. Do not touch When properly cared for, your grill will give safe, cooking surfaces, grill housing, Lide or any other reliable service for many years.
- Page 6 PRECAUTIONS WHEN LIGHTING A BURNER, ALWAYS PAY Keep the area surrounding the grill free from CLOSE ATTENTION TO WHAT YOU ARE DOING. combustible materials, trash, or combustible fluids BE CERTAIN YOU ARE TURNING THE IGNITER and vapors such as gasoline or charcoal lighter fluid. LABELED FOR THE BURNER YOU INTEND ON USING.
-
Page 7: Assembly Instructions
ASSEMBLY INSTRUCTIONS PLEASE READ THE INSTRUCTIONS CAREFULLY AND FOLLOW STEP BY STEP. TOOLS REQUIRED: Philips head screwdrivers (not provided), monkey wrench (not provided). Speci f i cat i on Q uant i t y I t em D escr i pt i on( SC ALE 1: 1) cr ossed r ound head scr ew 8pcs 1/ 4"... - Page 8 ASSEMBLY INSTRUCTIONS Step 2: Assemble bottom panel to side panels with four (4) pcs 1/4”*40mm screws as shown in figure below. Step 3: Assemble back panel to side panels with six (6) pcs 5/32”*10mm screws as shown in figure below.
- Page 9 ASSEMBLY INSTRUCTIONS Step 4: Assemble the doors and door frame to side panels with four (4) pcs 1/4”*40mm as shown in figure below.
- Page 10 ASSEMBLY INSTRUCTIONS Step 5: Assemble the spice rack on the left door with two (2) pcs 5/32”*10mm screws as shown in figure below. Step 6: Remove the head unit of grill. Insert the upper portion of the grill onto the cart from the top.
- Page 11 ASSEMBLY INSTRUCTIONS Step 7: Keep the main lid opening, take out cooking grid & flame tamer, then align the firebox and the cart with four (4) pcs 1/4”*10mm screws as shown in figure below. Step 8: Assemble the side shelf and the side burner with eight (8) pcs 1/4”*10mm screws as shown in figure below.
- Page 12 ASSEMBLY INSTRUCTIONS Step 9: Connect the quick connector as shown in figure below. Step 10: Assemble the side burner lid handle to side burner lid with two (2) pcs M4*6mm screws as shown in figure below.
- Page 13 ASSEMBLY INSTRUCTIONS Step11: Assemble the side shelf handle to side shelf with four (4) pcs 1/4”*10mm screws as shown in figure below. Step12: Hang up utensil hooks on the left side shelf as shown in figure below.
- Page 14 ASSEMBLY INSTRUCTIONS Step 13: The screws used to attach the rotisserie motor bracket are already screwed into the rotisserie motor bracket (see figure below). Remove the screws from rotisserie motor bracket, align the rotisserie motor bracket with the holes in the grill, and tighten up the screws.
-
Page 15: Gas Holder & Propane Tank Assembly
GAS HOLDER & PROPANE TANK ASSEMBLY Secure the gas tank onto the hole of bottom panel with the retention screw. With hand attach propane gas tank to regulator inlet fitting by turning the regulator clockwise until tight as shown in figure below. LP gas cylinder must be fitted with a listed overfill prevention device (OPD) CAUTION! ASSEMBLY TO PROPANE TANK.DO NOT USE TOOLS TO ATTACH... -
Page 16: To Match Light The Grill
TO MATCH LIGHT THE GRILL 1. If the burner will not light after several attempts then the burner can be match lit. 2. If you’ve just attempted to light the burner with the ignition, allow 5 minutes for any accumulated gas to dissipate. Keep your face and hands as far away from the grill as possible. -
Page 17: Gas Hook
GAS HOOK-UP Only the pressure regulator and hose assembly not come into contact with the grease tray or the grill head. supplied with the grill should be used. Any replacement pressure regulator and hose assembly CONNECTION: must be specified by the grill manufacturer. Your grill is equipped with gas supply orifices for use only with liquid propane gas. -
Page 18: Leak Testing
LEAK TESTING grill until all connections have been checked and do GENERAL Although all gas connections on the grill are leak not leak. tested at the factory prior to shipment, a complete gas tightness check must be performed at the Gas flow check: installation site due to possible mishandling in Each grill burner is tested and adjusted at the... -
Page 19: Installer Final Check
INSTALLER FINAL CHECK CHECKLIST Specified clearance maintained 24” from combustibles. All internal packaging removed. Knobs turn freely. Burners are tight and sitting properly on orifices. Pressure regulator connected and set for 11.2” W.C. L.P. gas. Gas connections to grill using hose &... -
Page 20: Operating Instruction
OPERATION INSTRUCTION GENERAL USE OF THE GRILL: Each main burner is rated at 12,000 Btu/hr. The main grill burners encompass the entire cooking area and are side ported to minimize blockage from falling grease and debris. Above the burners is stainless steel radiant (flame covers). -
Page 21: Lighting Instructions
LIGHTING INSTRUCTIONS Your grill has an exclusive patented built-in ignition. WARNING: IMPORTANT! The igniter is built in to the valve. To ignite each burner simply push and turn the control knobs to the HI setting, you will hear the valve click as it WARNING sends a spark to the pilot flame. -
Page 22: Lighting Illustrations
LIGHTING ILLUSTRATIONS Main Burner Lighting Illustration Side Burner Lighting Illustration 1. Push and turn the side burner knob to HI position 1. Make sure the lid is open 2. After the burner is lit, adjust the knob as desired 2. Push and turn one of main burner knob to HI position 3. -
Page 23: Care & Maintenance
CARE & MAINTENANCE IMPORTANT -Keeping outdoor cooking gas appliance area clear and free from combustible materials, gasoline and other flammable vapors and liquids. -Not obstructing the flow of combustion and ventilation air. -Keeping the ventilation opening(s) of the cylinder enclosure free and clear from debris. -Visually checking burner flames, with pictorial representations. -
Page 24: Exploded View
EXPLODED VIEW SF-2456-04 SF-AC-02 SF-AC-01 SF-2456-01 SF-AC-03 SF-2456-05 SF-2456-33 SF-AC-11 SF-AC-08 SF-2456-32 SF-2456-06 SF-AC-13 SF-AC-04 SF-AC-09 SF-2456-31 SF-2456-07 SF-2456-08 SF-2456-11 SF-2456-30 SF-2456-09 SF-2456-03 SF-AC-05 SF-2456-29 SF-2456-10 SF-2456-02 SF-2456-28 SF-AC-06 SF-AC-07 SF-2456-35 SF-2456-26 SF-2456-27 SF-2456-25 SF-2456-13 SF-2456-24 SF-2456-14 SF-2456-23 SF-2456-15 SF-2456-16 SF-2456-22 SF-2456-17 SF-2456-12... -
Page 25: Parts List
PARTS LIST MODEL # 720-0322 Sterling Forge SKU # SF2456 REF# DESCRIPTION Q’TY REF# DESCRIPTION Q’TY SF-AC-01 Name Plate,Lid SF-2456-13 Grease Tray SF-AC-02 Silver Heat Indicator SF-2456-14 Left Panel for cart SF-AC-03 Heat Insulating Spacer SF-2456-15 3″Caster SF-AC-04 Motor Bracket... -
Page 26: Trouble Shooting
TROUBLE SHOOTING SPIDER AND INSECT WARNING!!! 1. The smell of gas in conjunction with the burner Spiders and insects can nest in the burners of this flames appearing yellow. or any other grill, and cause the gas to flow from the 2. -
Page 27: Grilling Hints
GRILLING HINTS The doneness of meat, whether rare, medium, or Use a spatula instead of tongs or a fork to turn the well done, is affected to a large degree by the meat, as a spatula will not puncture the meat and thickness of the cut. - Page 28 Dot with butter or margarine. Wrap in heavy-duty foil. Grill, turning occasionally. Frozen Asparagus Medium 15 to 30 minutes Broccoli Brussels Sprouts Green beans Peas Place in aluminum foil pan. French fries Medium 15 to 30 minutes Grill, stirring occasionally. MEATS Beef Grill, turning once when juices...
- Page 29 Medium 1 inch Medium to 13 to 20 minutes 1-1/2 inch High 18 to 25 minutes Well-done 1 inch Medium 17 to 30 minutes Remove excess fat from edge. Slash remaining fat at 2-inch intervals. Pork Grill, turning once. Cook well Chops 1 inch Medium...
-
Page 30: Grill Recipe Suggestions
GRILL RECIPE SUGGESTION BBQ SALMON sprinkled with chopped parsley and a crisp salad, dressed with vinaigrette flavored with lettuce salad. fresh dill. 2 large salmon steaks 2 tbs. Oil Note: Substitute catfish, halibut or cod for BARBECUED LONDON BROIL Salt & pepper salmon. - Page 31 GRILL RECIPE SUGGESTION minutes on each side. While meat is 1 medium tomato, chopped salt and pepper cooking, heat tortillas on grill. Slice meat across grain in thin slices. Place on hot Roast eggplant on gas grill over medium platter. Squeeze lemon juice over. Wrap flame, turning occasionally until thoroughly Slide four prong meat hook down the length meat and any of the following toppings in...
-
Page 32: Limited Warranty
Our obligation under this warranty is limited to repair or replacement, at our option, of the product during the warranty period. The extent of any liability of Sterling Forge under this warranty is limited to repair or replacement. This warranty does not cover normal wear of parts, damage resulting from any of the following: negligent use or misuse of the product, use on improper fuel/gas supply, use contrary to operating instructions, or alteration by any person other than our factory service center.
Need help?
Do you have a question about the 720-0322 and is the answer not in the manual?
Questions and answers