Lansinoh Affinity PRO Instructions For Use Manual page 7

For Double Pumping
1. Make sure all tubes are attached to the tubing
connector
2. Hold the Breastmilk Expression Set to your
breasts so that the nipple is aligned to extend
straight toward the nipple tunnel of the breast
flange. Make sure the breast completely fills the
breast flange so that a vacuum is formed and
no air escapes. If you experience friction or
discomfort on your nipples, you may need a
different size flange. Larger size flanges are
also available. For more details, please call
800-292-4794 or visit www.lansinohstore.com.
The Breastmilk Expression Set and nipple tunnel
must tilt slightly downward to allow milk to flow
naturally toward the bottle.
3. Press and hold the On/Off Button for a few
seconds to turn the pump on. Lansinoh
Affinity® Pro Double Electric Pump will start in
the Stimulation Phase
After two minutes, the Stimulation Phase will
automatically change to the Expression Phase
in Pumping Rhythm Mode 2.
If you prefer to bypass the pre-set two minute
Stimulation Phase or your milk lets down sooner
than two minutes press the Stimulation/
Expression Toggle Button
Expression Phase,
select the pumping rhythm mode and suction
levels.
Note – the Pumping Rhythm Mode Indicator will
appear in the display to signify that you are in the
Expression Phase.
12
Note – if at any time the suction on your breast reaches uncomfortable levels, re-
duce the suction level by pressing the (-) button on the left side of the LCD screen.
You can control suction levels in both phases by pressing the + and - buttons.
4. The LCD has a timer which helps you keep track of how long you have pumped
.
to move to the
where you can separately
Using the Affinity
The pumping rhythm modes of the pump can be
changed using the Pumping Rhythm Mode Toggle
Button
pumping rhythm modes. Every mom is different,
so we have provided three different pumping
rhythms so you can maximize your milk production
and comfort. You should try all three modes to
determine which works best for you.
so you can manage your time effectively. When a pumping session is finished,
turn the pump off with the on/off button. After turning the pump off, the display
will remain on for a few seconds. Make sure there is no suction on the nipple(s)
before removing the breast flanges from the breast. If necessary, break the
suction by inserting a finger between the breast flange and the breast. Once
the suction is broken, the breast flange can be removed safely.
Please note: LCD display back light will automatically switch off if no control
buttons are pressed for 20 seconds in order to save power. If the pump unit is
left switched on and unattended for more than 60 minutes, the control system
will automatically switch the power off. You have to press and hold the power-on
button in order to switch the unit back on again.
NOTE: If the suction on your breast reaches uncomfortable levels,
reduce the suction level by pushing the – Suction button, or discon-
nect the tubing connector from its receptacle on the electric pump.
For Single Pumping
Some moms prefer to pump on one side while they feed their baby on the other.
If you choose to single pump, simply remove one tube and close the tubing
connector. Make sure that
the plug is placed into the
pipe outlet properly and
pushed in securely.
® Breast Pump
. Pressing this button will toggle between
13