Special Operating Notes; Training Guide - First Alert FaBCSS1 SERIES Instruction Manual

The First Alert™ Bark Control Collar will recall the last setting or the
default setting (level 1 or low).
STep 2: Set correction level by pressing and holding (approximately
2 seconds) the Control Button.
Once the collar is ON press the Control Button once to toggle to the next
correction level. You will need to test your dog to see which correction
level is appropriate for your dog's temperament. Always begin training
with the First Alert™ Bark Control Collar on level 1. If your dog does not
respond to the Static Correction on level 1 change the setting to level 2.
If there is no response from your dog at level 2 change the setting to level
3. The table on page 3 describes the correction level settings.
STep 3: Attach collar to your dog as you did in the COLLAR FITTING stage.

SPECIAL OPERATING NOTES

Turn unit off when not in use to conserve battery life.
The First Alert™ Bark Control Collar retains the LAST correction level
setting and will resume this mode when the unit is turned on.
The LED of the setting chosen will illuminate GREEN when a bark has
been detected and a correction is being administered.
OveR CORReCTION MODe: If excessive barking is detected the bark
control system will enter a mode designed to shut down the system.
The LED of the selected setting will illuminate RED and will automatically
reset. You can manually reset the system by pressing and hold the Main
Control Button.
LOw BATTeRY MODe: LED light will flash RED for 5 seconds when the
battery needs to be replaced.
Proper training is essential to achieving the best results from the
First Alert™ Bark Control Collar for you and your dog. When first starting
to use the bark control collar, you should closely monitor your dog's
reaction when barking behavior is exhibited.
When you begin using the bark control collar, your dog should be inside
a protected area. The protected area should not be a cage, crate, or

TRAINING GUIDE