Collar Fitting - First Alert FaBCSS1 SERIES Instruction Manual

• When replacing batteries after usage you
must completely discharge the collar by
holding a plastic handle screwdriver across
both stainless steel probes for 5 seconds.
Make sure the
metal portion of the screwdriver is touching
both stainless steel probes and the unit is in
the OFF position.

COLLAR FITTING

Proper fit of the First Alert™ Bark Control
Collar is essential to establish a good training
foundation and optimal performance.
Note: Batteries should be installed properly
and the collar should be in the OFF position
before proceeding with fitting the collar to
your dog.
STep 1: Ensure dog is in a relaxed position.
STep 2: With the collar clasp open loosen
the adjustment buckle such that it can reach
completely around your dog's neck (
Place inward microphone directly over the
dog's
voicebox. When buckled, the collar should rest
directly behind the dog's ears (the highest
part
of the neck). (
fig. 5)
Note: Make sure both stainless steel probes
go through the coat completely and make
contact with the skin.
Use the longer stainless steel probes if the coat
does not allow the shorter probes to reach
the skin.
Before changing the stainless steel probes you
must completely discharge the collar by holding
a plastic handle screwdriver across both stainless steel probes for 5
seconds. Make sure the metal portion of the screwdriver is touching both
stainless steel probes and the unit is in the OFF position.
fig. 4).
figure 4
figure 5
figure 6
figure 7
figure 8
(continued)