Table of Contents
Advertisement
▷
Installation behind the front seats, arrows 1.
▷
Installation behind the rear seats, arrows 2.
Label
Ensure that the partition net is correctly posi‐
tioned, i.e., do not reverse front and back.
The partition net is labeled accordingly.
Installation behind the rear seats
1.
If necessary, tilt the rear seat backrests for‐
ward and remove the front cargo cover, refer
to page 115.
2.
Fold open the cover caps 1 of the rear brack‐
ets in the headliner to the point where they
engage.
3.
Insert the rods of the partition net 2 all the
way into the holders on both sides and slide
forward.
Online Edition for Part no. 01 40 2 914 595 - VI/12
Interior equipment
4.
Attach the hooks 1 at the bottom of the re‐
taining straps into the eyelets on the rear
seat backrest, arrow, on both sides.
5.
Lash the partition net tightly. To do this,
tighten the retaining straps using the ten‐
sioning buckles.
Installation behind the front seats
1.
Fold down the rear seat backrests, refer to
Enlarging the cargo area.
2.
Fold open the cover caps of the front brack‐
ets in the headliner to the point where they
engage.
3.
Insert the rods of the partition net all the way
into the holders on both sides and slide for‐
ward.
4.
Attach the hooks at the bottom of the re‐
taining straps into the upper eyelets on the
rear seat backrest on both sides.
5.
Lash the partition net tightly. To do this,
tighten the retaining straps using the ten‐
sioning buckles.
Controls
117
Advertisement
Table of Contents
