Changing The Shock Sensor (It-S) Settings; Emergency Disarm Procedure - Ford Gen-2 Gold Owner's Manual

System Maintenance (Con't)

Changing the Shock Sensor (IT-s) settings:

Your PowerCode systems IT-s sensitivity settings can be tailored to your individual
requirements. Your installer at the time of installation has set your IT-s to a medium
sensitivity. To make your systems IT-s either more or less sensitive, follow these
steps:
1. Follow the instructions on the previous page to put your system in transmitter
learn mode.
2. Press and release the programming/override button
The system will chirp the horn four times to acknowledge the system in option
settings mode.
3. Press* the button on your PowerCode remote control transmitter one time.
The system will chirp the horn one time. Your "Lite-touch" sensitivity can now
be increased by pressing* the
transmitter or decreased by pressing* the
control transmitter. The system chirps the horn one time each time either
button is pressed.
4. Press* the button on your PowerCode remote control transmitter one time.
The system will chirp the horn two times. Your "Full shock" sensitivity can now
be increased by pressing* the
transmitter or decreased by pressing* the
control transmitter. The system chirps the horn one time each time either
button is pressed.
5. Turn the ignition key off to exit programming mode and save settings.
After changing your shock sensor settings, it is recommended that you arm your
security system and double check your settings. A setting too high can cause the
system to "false alarm". Conversely, a setting too low could prevent the system from
adequately protecting your vehicle.

Emergency Disarm Procedure

If your remote control transmitter is lost or fails to function, use this procedure to
disarm the system and start your vehicle.
1. Use the keys to enter the vehicle. The alarm will sound once the door is opened.
2. Insert the key into the ignition and turn to the ON position.
3. Locate and press the programming/override button mounted under the instrument
panel. The alarm will turn off and you will be able to start your vehicle.
* "Press" refers to pushing a transmitter button for approximately one second.
Gen-2 Gold Owners, 1031555 RevA - TRANSLATED.pmd
button on your PowerCode remote control
on your PowerCode remote
button on your PowerCode remote control
on your PowerCode remote
13
13
6/14/2006, 2:45 PM