Led Indicators - Axis M3006–V User Manual

AXIS M3006–V Network Camera
Hardware Overview
NOTICE
The product shall be connected using a shielded network cable (STP). All cables connecting the product to the network switch
shall be shielded (STP) and intended for their specific use. Make sure that the network switch is properly grounded. See
Electromagnetic Compatibility (EMC)
SD card slot - A standard or high-capacity microSD card (not included) can be used for local recording with removable storage.
NOTICE
To prevent corruption of recordings, the SD card should be unmounted before removal. To unmount, go to Setup > System
Options > Storage > SD Card and click Unmount.
Control button - The control button is used for:
• Connecting to an AXIS Video Hosting System service. See
1 second until the Status LED flashes green.
• Connecting to AXIS Internet Dynamic DNS Service. See
about 3 seconds.
• Resetting the product to factory default settings. See

LED Indicators

Color Indication
Unlit Connection and normal operation
Amber
Steady during startup. Flashes during firmware upgrade.
Amber/red Flashes amber/red if network connection is unavailable or lost.
Red Flashes red for firmware upgrade failure.
Green Shows steady green for 10 seconds for normal operation after restart.
Note
• The Status LED can be configured to flash while an event is active.
• The Status LED can be configured to flash for identifying the unit. Go to Setup > System Options > Maintenance .
for regulatory requirements.
page 44
5
page 37
. To connect, press and hold the button for about
page 37
. To connect, press and hold the button for
.