Events - Axis M3006–V User Manual

AXIS M3006–V Network Camera

Events

Events
The Axis product can be configured to perform actions when different events occur, for example, start a recording when motion is
detected. The set of conditions that defines how and when the action is triggered is called an Action Rule.
Available Action Rule triggers and conditions include:
Applications — use installed applications to trigger the rule, see
•
Detectors
•
Motion Detection — trigger the rule when motion is detected, see
-
- Tampering — trigger the rule when tampering is detected, see
Hardware
•
Network — trigger the rule if network connection is lost or restored. This can for example be used to start
-
recording to the SD card.
Input Signal
•
- Manual Trigger — trigger the rule using the Manual Trigger button in the Live View page, see
the Live View Page on page 9
and configuration.
PTZ
•
- Moving — trigger the rule when the camera view moves due to a PTZ operation. This can for example be used
as an additional condition to prevent an action rule triggered by motion detection to record video while the
camera view moves due to a PTZ operation.
Preset Reached — trigger the rule when the camera stops at a preset position. This can be for example be used
-
with the Send Images action to upload images from the preset position.
Storage
•
- Available — trigger the rule when the storage device is unmounted or removed. This can for example be
used to send maintenance notifications.
- Full — trigger the rule when the storage device is full. Under normal operation, the oldest recordings will be
overwritten to prevent the storage device from becoming full.
- Locked — trigger the rule if the storage device is locked (write protected).
System
•
System Initializing — trigger the rule when the product is being started. This can for example be used to send a
-
notification when the product restarts.
Time
•
- Recurrence — trigger the rule periodically, see
an image every 5 minutes.
- Use Schedule — trigger the rule according to the selected schedule, see
Available actions include:
PTZ Control
•
Preset Position — go to a preset position.
-
Guard Tour — start a guard tour, see
-
Applications on page 28
. This can for example be used to validate actions during product installation
Recurrences on page 31
Guard Tour on page 24
29
.
Motion Detection on page 25
Camera Tampering on page 25
. This can for example be used to upload
Schedules on page 31
.
.
.
Controls on
.