Warnings And Disclosures - Dickinson 00-NEW-P9000 Installation And Operating Manual

Warnings and Disclosures

- Follow all installation and operating procedures.
- Do not use high pressure propane.
- The propane heater requires an installed flue for correct operation.
Do not attempt to operate the heater without the flue chimney installed correctly as
required in this manual.
- If the information in this manual is not followed exactly, a fire or explosion may result
causing property damage, personal injury, or loss of life.
- Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this
or any other appliance.
- Do not use substitute valves, burners, or fan motors
- Turn off the heater when refueling.
- Do not install this appliance in spaces containing internal combustion engines, fuel
tanks, or joints and fittings of their fuel systems.
- Use only approved materials, hose, regulators and fittings to install.
10ft Hose – ULC Type III CGA St 8.1 – Dickinson Prt# 19-100-10
20ft Hose – ULC Type III CGA St 8.1 – Dickinson Prt# 19-100-20
Propane Low Pressure Regulator UL/C.G.A – Dickinson Prt# 19-151
- Installation must conform with local codes or in the absence of codes, with current
National Fuel Gas Code, ANSI Z223.1 or current CAN/CGA B149, Installation Codes.
- Manufactured or mobile home installation must conform to Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280, or, when not applicable, the
Standard for Fire Safety Criteria for Manufactured Home Installation Sites and
Communities, ANSI/NFPA 501A,(USA) or Mobile Homes Standard, CAN/CSA-Z240
MH Series, in Canada
- Main gas valve must be disconnected from gas supply system during any pressure test
of the system at pressures greater than ½ psi (3.5 kPa, 27.4mBar)
- DO NOT OPERATE THIS HEATER UNATTENDED !
-2-
This heater requires a low pressure regulator