Table of Contents
Advertisement
The diagram is to illustrate a typical installation only and should not be used to illustrate
any particular regulatory code, insurance requirement or to override manufacturer's
instructions on any fittings or components.
Install your propane system in accordance to local, national or industry specific
regulations. Retain the installation and owner's manual for your gas components such as
the solenoid and regulator. Installation requirements for some of these components vary
by manufacturer. Install components as directed by manufacturer's instructions.
Electrical
- The fan is 12VDC and the power supply must be brought to the wire connectors of the
fan ON/OFF switch through the grommet installed.
approved and EM compliant for FCC and CSA regulations. The fan must have an inline
fuse rated at 2 amps
- Use of the blower fan is optional but greatly enhances heat output and hot air
circulation.
- If applicable, this appliance must be electrically grounded in accordance with local
codes or in absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or
the Canadian Electrical Code, CSA C22.21.
WARNING:
DO NOT touch the heater during operation: the glass window, external surfaces and the
vent pipe of the heater get very hot and may cause burns
ATTENTION:
NOTE: ONLY ON FIRST LIGHTING the lubricating oil on the stainless steel pipe will
produce smoke and burn off. THIS IS NORMAL. We suggest that windows and hatches
be opened. Smoke from the inside pipe will be emitted outside, through the flue cap.
WARNING:
NOT closing the door of the heater properly may cause
•
depletion of oxygen within the cabin
•
exhaust gas to enter the cabin, possibly including Carbon Monoxide (CO).
Carbon Monoxide (CO) is a colorless, tasteless, invisible toxic gas, which can cause serious
health problems or death.
-9-
The fan on this heater is CE
.
Advertisement
Table of Contents
