Advertisement
www.collegehillshonda.com
Installing the Subwoofer Switch
27. Get the audio panel removed in step 6. Using a
utility knife, cut off the rib from the back of the
audio panel in the area shown.
UTILITY
KNIFE
RIB
AUDIO PANEL
22 mm
15 mm
20 mm HOLE SAW
28. On the front of the audio panel measure and mark
the panel in the area shown. Using an awl, center
punch the marked location.
29. While wearing eye protection, drill a 20 mm hole
through the audio panel at the marked location
using a 20 mm hole saw. Remove any burrs from
the edge of the hole with a file.
30. Install the subwoofer switch into the 20 mm hole
in the audio panel.
SUBWOOFER SWITCH
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
BACK OF
AUDIO PANEL
15 mm
AUDIO
20 mm
PANEL
FELT-TIP
PEN
AWL
3403181M
AUDIO PANEL
3403190M
31. Slide the audio unit into the center panel opening,
plug in the vehicle connector and the antenna
lead, and reinstall the four bolts.
AUDIO
UNIT
BOLT
(reused)
BOLT
(reused)
32. Hold the audio panel near the audio unit panel
opening; connect the subwoofer harness 2-pin
connector and the vehicle connectors into the
audio panel, then reinstall the audio panel.
VEHICLE CONNECTOR
AUDIO
PANEL
AII 25876 (0308)
VEHICLE
ANTENNA
CONNECTOR
LEAD
AUDIO
BRACKET
SUBWOOFER
2-PIN CONNECTOR
3403200M
3403210M
7 of 8
Advertisement
