Celestron NightScape 95555 Brochure & Specs page 8

attaChiNg NightsCape to telesCope
Before attaching nightscape to your telescope, remember to first power it down and
disconnect all cables. nightscape has a 2" adapter with internal t-threads that
allows it to be attached in two ways:
Drawtube – slide the 2" nosepiece adapter directly into your telescope's 2" focuser
and secure using the thumb screws on the telescope.
t-thread – thread your t-Adapter (sold separately) onto the 2" nosepiece or direct-
ly into the camera housing (with the 2" nosepiece removed). Attach the t-Adapter
securely to your telescope.
As the distance from the top of the nosepiece to the imaging sensor is the same
as the distance of a standard dslr camera (55 mm), celestron edgeHd t-Adapters
provide the correct spacing for attaching nightscape to an edgeHd telescope. Model
#93644 (edgeHd 8") and #93646 (edgeHd 9.25", 11" and 14").
guidesCoPe (not inCLuded)
CPC dLx edge hd (not inCLuded)
t-adaPter (not inCLuded)
nightsCaPe attaChed
figure 4
www.celestron.coM