Installing The Drivers - Celestron NightScape 95555 Brochure & Specs

poweriNg NightsCape
Before attaching nightscape to your telescope, power the camera on to make sure it
is working properly.
1. Attach the smaller end of the UsB cable to the camera port
labeled "Pc".
2. Attach the larger end of the UsB cable to your computer's UsB port.
3. Plug the barrel connector end of the 12V dc power cable into the camera port
labeled "12V dc".
4. Plug the cigarette lighter adapter end of the 12V dc power cable into the 12V
outlet in your car, Powertank or other 12V power supply. Alternatively you can use
the optional 110V Ac to 12V dc adapter (model #18778).
5. nightscape should automatically power on. You should hear
(and feel) the fan operating.

iNstalliNg the DriVers

once nightscape is connected, the computer should automatically connect to the In-
ternet and install necessary drivers. If you do not have an Internet connection, follow
the installation wizard and allow the computer to browse you computer's cd-roM
drive for the "nightscape drivers" folder located on the cd-roM.
iNstalliNg asCom DriVers
If you wish to install AscoM drivers from the cd, you must first install AstroFX as
described above and also the AscoM Platform 6 from the following web site: http://
ascom-standards.org/. once installed press the "AscoM driver" button to install
driver. see Fig 2a.
www.celestron.coM