Record Power AC400 Original Instruction Manual page 7

General Health & Safety Guidance
• Remember always to switch off and unplug the machine
from the power supply before carrying out any setting up
or maintenance operations.
• Follow any instructions for the maintenance of
accessories and consumables.
• Do not use compressed air to clean the machine. Always
use a brush to dislodge dust in places that are awkward
to reach and a dust extractor to collect the waste.
• Inspect electric cables periodically and, if damaged,
have them replaced by an authorised service facility or
qualified electrician.
• Inspect extension cables (if used) periodically and replace
if damaged.
28. Keep cutting tools sharp and clean
• Correctly maintained cutting tools are easier to control
and less likely to bind.
• Cutting tools and blades can become hot during use.
Take extreme care when handling them and always allow
them to cool before changing, adjusting or
sharpening them.
29. Disconnect the machine from the power supply
• When not in use, before servicing, changing blades etc.
always disconnect the machine from the power supply.
30. Check for damaged parts
• Before each use of the machine, it should be carefully
checked to determine that it will operate properly and
perform its intended function.
• Check for alignment of moving parts, binding of moving
parts, breakage of parts and any other conditions that
may affect the operation of the machine.
• A guard or other part that is damaged should be properly
repaired or replaced by a qualified person unless
otherwise indicated in this instruction manual.
• Do not use the machine if the switch does not turn the
machine 'ON' and 'OFF'.
• Have defective switches replaced by a qualified person.
31. Warning!
• The use of any accessory or attachment, other than
those recommended in this instruction manual, or
recommended by our Company may present a risk
of personal injury or damage to the machine and
invalidation of the warranty.
32. Have your machine repaired by a
qualified person
• This machine complies with the relevant safety rules
and standards appropriate to its type when used in
accordance with these instructions and with all of the
standard safety guards and equipment in place. Only
qualified persons using original spare parts should carry
out repairs. Failure to do this may result in considerable
danger to the user and invalidation of warranty.
33. Caution! Motor may become hot during use
• It is normal for motors on some machines to become hot
to the touch during use. Avoid touching the motor directly
when in use.
7