Connecting To An Analog Tv (Composite); Connecting A Splitter For Picture-In-Picture Tvs; Connecting Audio Equipment - HP MR4000N User Manual

Connecting to an analog TV (composite)

1 Connect your indoor or outdoor antenna to the RF Input (labeled AIR 75 ohm).
2 Insert the yellow cable into the Video connector in the Monitor Out section.
3 Insert the white and red audio cables into the L and R Audio connectors of the Monitor Out section.
4 Insert the other end of the yellow cable into the Composite In connector of your TV.
5 Insert the other ends of the white and red audio cables into the L and R In connectors of your TV or
audio receiver. Make sure they correspond with your composite input.
6 Select 480i for your Resolution setting.

Connecting a splitter for Picture-In-Picture TVs

To use the Picture-in-picture feature on your TV, use a splitter (not included) to connect your
HDTV Tuner.
1 Connect your indoor or outdoor antenna to the splitter.
2 Connect one cable from the splitter to the RF Input (labeled AIR 75 ohm) on the HDTV Tuner.
3 Connect another cable from the splitter to the RF connector on your TV.

Connecting audio equipment

This connection enables Dolby Digital* quality sound, when available. Use with an external digital
audio receiver decoder. See "Digital Output" on page 20 for configuring your HDTV Tuner to output
the appropriate audio format for your receiver.
Insert the cable from the Digital Audio Input of the audio receiver into the Digital Audio Out connector
on your HDTV Tuner. Refer to your TV documentation to locate the Digital Audio Input connector.
*Manufactured under license from Dolby Laboratories. "Dolby" and the Double-D symbol are
trademarks of Dolby Laboratories.
7
Setup