neuhaus laboratories T-2 Owner's Manual page 6

POWER ON
Your new amplifier is ready for operation after the speakers, power cord, signal
or USB cables have been properly installed. When you are sure the connections
are correct, adjust the "VOLUME" to the minimum and push the power button
located on the center of the front panel to the "ON" position. Observe that the
Blue LED and all vacuum tubes are lit. The slow power up protects you
components. The amp will be ready to play in about 15 seconds.
NOTICE: The sound quality will be affected by all the elements of the audio
chain: recording, recorded medium, source, amplifier, speakers and room. We
therefore recommend that you select quality inputs and quality speakers to
perform with the neuhaus laboratories T-2 amplifier.
COMPUTER AUDIO: USE OF THE WITH USB PORT on the neuhaus
laboratories T-2 amp.
WINDOWS OPERATING SYSTEMS
WINDOWS COMPATIBLE
When your computer is "ON", you will find a new USB device in the "Device
Manager" (Windows XP): USB Speakers. The amplifier is designed for "Plug &
Play" set up and in most cases the audio signal from your computer should play
through the amplifier without requiring any additional adjustment. If the audio
from your computer cannot be heard through the amplifier and you are using
Windows XP, first click on the "speaker" icon at the bottom right corner of your
screen and adjust the sound output to the maximum position. If you still cannot
hear your computer: go to the Windows "Control Panel" and select "Sounds and
Audio Devices" (XP) or "Multimedia" (98SE, ME, 200). Under the "Audio" tab,
choose C-Media USB Audio for "Sound Playback". Your PC sound will now play
through your neuhaus laboratories T-2 tube amplifier. The sound level can
be adjusted from the "speaker bar" on your computer and should be placed at
maximum so main volume is controlled by the T-2 amp.
MAC OPERATING SYSTEMS
MAC COMPATIBLE
Plug the USB cable into the USB port of your Mac computer. Select "Sound" in
System Preferences. Under the "Output" tab, select "C-Media USB Audio".
Your Mac's sound will now play through your neuhaus laboratories T-2 tube
amplifier.