Completing The Connections; Testing The Connections; Mounting The Stereo - Optimus High-Power In-Dash AM/FM Stereo CD Player Owner's Manual

12-2152.fm Page 11 Wednesday, July 14, 1999 2:48 PM

Completing the Connections

Make sure you have securely made all
other connections, then plug the har-
ness' connector into the stereo's 14-pin
wiring socket. Reconnect the cable to
the vehicle battery's negative terminal.
(illus)
TESTING THE
CONNECTIONS
Turn on your vehicle's ignition and in-
stall your stereo's control panel (see
"Installing the Control Panel" on
Page 14). The display should light
when you press
ON/OFF
stereo.
If the stereo does not work, immedi-
ately disconnect the cable from
your vehicle battery's negative (–)
terminal. Then recheck your connec-
tions.
Caution: If you played a CD while
testing the connections, be sure to re-
move the CD from the stereo before
continuing.
After you verify that the display lights,
follow the instructions in "Mounting the
Stereo."

MOUNTING THE STEREO

Be sure you verify that the stereo is
connected properly. See "Making the
Connections" on Page 7. Then follow
these steps to mount the stereo.
1. Disconnect the cable from the
2. Disconnect the wire harness and
to turn on the
3. Press
vehicle battery's negative (–) ter-
minal.
(new illus)
the antenna.
(new illus)
on the lower right-hand
RLS
corner of the control panel to
remove the control panel.
11