IBM iL2120 User Manual page 40

6. Grasp and lift the pull tab 1 and lift the module out. Dispose of the
7. Install the new lamp module, being sure to align the connectors properly.
8. Push the module in until it is flush with the bottom case of the projector.
9. Tighten the screws on the outside of the module.
10. Replace the lamp-module door by inserting the hooks on the rear of the
11. Plug in the power cord to turn the projector back on.
12. To reset the lamp-hour counter in the Status window, press and hold the
Replacing the batteries in the remote control
The life of the batteries depends on how often and how long you use the
remote control. Symptoms of low battery charge include erratic responses
when you use the remote control and a reduced range of operation.
Follow these steps to replace the batteries:
30
iL2120 IBM Value Data/Video Projector, iL2220 Conference Room Data/Video Projector: User's Guide
lamp module in an environmentally proper manner.
WARNING:
Do not drop the lamp module or touch the glass bulb. The glass
might shatter and cause injury.
lamp-module door into the projector and pressing the lamp-module door
into place. If the lamp-module door does not fit properly or bulges out,
remove the door and re-seat the lamp module.
volume - button, then press the menu button (while still holding down
the volume - button) for 5 seconds. Verify that the counter was reset by
pressing the menu button and viewing the counter in the Status window.